User's Manual 764 Document #: LTRT-10466
Mediant 500L MSBR
62.5 Configuring Basic Test Call
The Basic Test Call feature tests incoming Gateway calls from a remote SIP endpoint to a
simulated test endpoint on the device. The only required configuration is to assign a prefix
number (test call ID) to the simulated endpoint. All incoming calls with this called
(destination) prefix number is identified as a test call and sent to the simulated endpoint.
The figure below displays a basic test call example.
Figure 62-4: Incoming Test Call Example
To configure basic call testing:
1. Open the Test Call Settings page (Configuration tab > System menu > Test Call >
Test Call Settings).
Figure 62-5: Test Call Settings Page
2. In the 'Test Call ID' field, enter a prefix for the simulated endpoint.
3. Click Submit.
Notes:
• The Basic Test Call feature tests incoming calls only and is initiated only upon
receipt of incoming calls with the configured prefix.
• For a full description of this parameter, see ''SIP Test Call Parameters'' on page
806.
• This call test is done on all SIP interfaces.
• This call test is applicable only to the Gateway application.
To Next Page
Loading...
