AudioCodes Mediant 500L MSBR

User's Manual 876 Document #: LTRT-10466
Mediant 500L MSBR
67.9 Channel Parameters
This subsection describes the device's channel parameters.
67.9.1 Voice Parameters
The voice parameters are described in the table below.
Table 67-34: Voice Parameters
Parameter Description
Web/EMS: Input Gain
CLI: input-gain
[InputGain]
Global parameter that defines the pulse-code modulation (PCM)
input (received) gain control level (in decibels). You can also
configure this functionality per specific calls, using IP Profiles
(IpProfile_InputGain) or Tel Profiles. For a detailed description of this
parameter and for configuring this functionality in the IP Profile table,
see ''Configuring IP Profiles'' on page 332 or in the Tel Profile table,
see Configuring Tel Profiles on page 327.
Note: If this functionality is configured for a specific profile, the
settings of this global parameter is ignored for calls associated with
the profile.
Web: Voice Volume
EMS: Volume (dB)
CLI: voice-volume
[VoiceVolume]
Global parameter that defines the voice gain control (in decibels).
This defines the level of the transmitted (IP-to-Tel) signal. You can
also configure this functionality per specific calls, using IP Profiles
(IpProfile_VoiceVolume) or Tel Profiles. For a detailed description of
this parameter and for configuring this functionality in the IP Profile
table, see ''Configuring IP Profiles'' on page 332 or in the Tel Profile
table, see Configuring Tel Profiles on page 327.
Note: If this functionality is configured for a specific profile, the
settings of this global parameter is ignored for calls associated with
the profile.
EMS: Payload Format
CLI: G726-voice-payload-
format
[VoicePayloadFormat]
Determines the bit ordering of the G.726 voice payload format.
 [0] = (Default) Little Endian
 [1] = Big Endian
Note: To ensure high voice quality when using G.726, both
communicating ends should use the same endianness format.
Therefore, when the device communicates with a third-party entity
that uses the G.726 voice coder and voice quality is poor, change
the settings of this parameter (between Big Endian and Little
Endian).
Web: MF Transport Type
CLI: MF-transport-type
[MFTransportType]
Currently, not supported.
Web: Silence Suppression
EMS: Silence Compression
Mode
CLI: silence-compression-
mode
[EnableSilenceCompression
]
Global parameter that enables the Silence Suppression feature. You
can also configure this functionality per specific calls, using IP
Profiles (IpProfile_SCE). For a detailed description of this parameter
and for configuring this functionality in the IP Profile table, see
''Configuring IP Profiles'' on page 332.
Note: If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated with
the IP Profile.