User's Manual 196 Document #: LTRT-10466
Mediant 500L MSBR
To configure jitter buffer using the Web interface:
1. Open the RTP/RTCP Settings page (Configuration tab > VoIP menu > Media >
RTP/RTCP Settings). The relevant parameters are listed under the 'General Settings'
group, as shown below:
Figure 17-3: Jitter Buffer Parameters in the RTP/RTCP Settings Page
2. Set the 'Dynamic Jitter Buffer Minimum Delay' parameter (DJBufMinDelay) to the
minimum delay (in msec) for the Dynamic Jitter Buffer.
3. Set the 'Dynamic Jitter Buffer Optimization Factor' parameter (DJBufOptFactor) to the
Dynamic Jitter Buffer frame error/delay optimization factor.
4. Click Submit.
17.3.2 Comfort Noise Generation
The device can generate artificial background noise, called comfort noise, in the voice
channel during periods of silence (i.e. when no call party is speaking) for Gateway calls.
This is useful in that it reassures the call parties that the call is still connected. The device
detects silence using its Voice Activity Detection (VAD) mechanism. When the Calling
Tone (CNG) is enabled and silence is detected, the device transmits Silence Identifier
Descriptors (SIDs) parameters to reproduce the local background noise at the remote
(receiving) side.
The Comfort Noise Generation (CNG) support also depends on the silence suppression
(SCE) setting for the coder used in the voice channel. For more information, see the
description of the CNG-related parameters.
The following procedure describes how to configure CNG using the Web interface.
To configure CNG using the Web interface:
1. Open the RTP/RTCP Settings page (Configuration tab > VoIP menu > Media >
RTP/RTCP Settings). The relevant parameters are listed under the 'General Settings'
group, as shown below:
Figure 17-4: Comfort Noise Parameter in RTP/RTCP Settings Page
2. Set the 'Comfort Noise Generation Negotiation' parameter (ComfortNoiseNegotiation)
to Enable.
3. Click Submit.
Note: This feature is applicable only to the Gateway application.
To Next Page
Loading...
