AudioCodes Mediant 500L MSBR

User's Manual 67. Configuration Parameters Reference
Version 6.8 783 Mediant 500L MSBR
Parameter Description
username/old/new
[WelcomeMessage]
Enables and defines a Welcome message that appears on the
Web Login page for logging in to the Web interface.
The format of this parameter is as follows:
[WelcomeMessage ]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text
[\WelcomeMessage]
For Example:
FORMAT WelcomeMessage_Index = WelcomeMessage_Text
WelcomeMessage 1 = "**********************************" ;
WelcomeMessage 2 = "********* This is a Welcome message
***" ;
WelcomeMessage 3 = "**********************************" ;
Notes:
 Each index row represents a line of text in the Welcome
message box. Up to 20 lines (or rows) of text can be defined.
 The configured text message must be enclosed in double
quotation marks (i.e., "...").
 If this parameter is not configured, no Welcome message is
displayed.
67.1.3 Telnet Parameters
The Telnet parameters are described in the table below.
Table 67-3: Telnet Parameters
Parameter Description
Web: Embedded Telnet Server
EMS: Server Enable
CLI: telnet
[TelnetServerEnable]
Enables the device's embedded Telnet server. Telnet is disabled by
default for security.
 [0] Disable
 [1] Enable Unsecured (default)
 [2] Enable Secured
Note: Only the primary Web User Account (which has Security
Administration access level) can access the device using Telnet
(see ''Configuring Web User Accounts'' on page 64).
Web: Telnet Server TCP Port
EMS: Server Port
CLI: telnet-port
[TelnetServerPort]
Defines the port number for the embedded Telnet server.
The valid range is all valid port numbers. The default port is 23.
Web: Telnet Server Idle
Timeout
EMS: Server Idle Disconnect
CLI: idle-timeout
[TelnetServerIdleDisconnect]
Defines the timeout (in minutes) for disconnection of an idle Telnet
session. When set to zero, idle sessions are not disconnected.
The valid range is any value. The default is 0.
Note: For this parameter to take effect, a device reset is required.
Web: Maximum Telnet
Sessions
CLI: telnet-max-sessions
[TelnetMaxSessions]
Defines the maximum number of permitted, concurrent Telnet/SSH
sessions.
The valid range is 1 to 5 sessions. The default is 2.
Note: Before changing the value, make sure that not more than this
number of sessions are currently active; otherwise, the new setting