EasyManua.ls Logo

AudioCodes Mediant 500L MSBR

AudioCodes Mediant 500L MSBR
1042 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User's Manual 814 Document #: LTRT-10466
Mediant 500L MSBR
67.4 Security Parameters
This subsection describes the device's security parameters.
67.4.1 General Security Parameters
The general security parameters are described in the table below.
Table 67-21: General Security Parameters
Parameter Description
Firewall Table
Web/EMS: Internal Firewall
Parameters
CLI: configure voip > access-list
[AccessList]
This table parameter defines the device's access list (firewall),
which defines network traffic filtering rules.
The format of this parameter is as follows:
[AccessList]
FORMAT AccessList_Index = AccessList_Source_IP,
AccessList_Source_Port, AccessList_PrefixLen,
AccessList_Source_Port, AccessList_Start_Port,
AccessList_End_Port, AccessList_Protocol,
AccessList_Use_Specific_Interface, AccessList_Interface_ID,
AccessList_Packet_Size, AccessList_Byte_Rate,
AccessList_Byte_Burst, AccessList_Allow_Type;
[\AccessList]
For example:
AccessList 10 = mgmt.customer.com, , , 32, 0, 80, tcp, 1, OAMP,
0, 0, 0, allow;
AccessList 22 = 10.4.0.0, , , 16, 4000, 9000, any, 0, , 0, 0, 0, block;
In the example above, Rule #10 allows traffic from the host
‘mgmt.customer.com’ destined to TCP ports 0 to 80 on interface
OAMP (OAMP). Rule #22 blocks traffic from the subnet
10.4.xxx.yyy destined to ports 4000 to 9000.
For a detailed description of this table, see ''Configuring Firewall
Settings'' on page 165.
Media Latching
Web/EMS: Inbound Media
Latch Mode
CLI: inbound-media-latch-mode
[InboundMediaLatchMode]
Enables the Media Latching feature.
[0] Strict = Device latches onto the first original stream (IP
address:port). It does not latch onto any other stream during the
session.
[1] Dynamic = (Default) Device latches onto the first stream. If it
receives at least a minimum number of consecutive packets
(configured by New<media type>StreamPackets) from a
different source(s) and the device has not received packets
from the current stream for a user-defined period
(TimeoutToRelatch<media type>Msec), it latches onto the next
packet received from any other stream. If other packets of a
different media type are received from the new stream, based
on IP address and SSRC for RTCP/RTP and based on IP
address only for T.38, the packet is accepted immediately.
Note: If a packet from the original (first latched onto) IP
address:port is received at any time, the device latches onto
this stream.
[2] Dynamic-Strict = Device latches onto the first stream. If it

Table of Contents

Other manuals for AudioCodes Mediant 500L MSBR

Related product manuals