AudioCodes Mediant 500L MSBR

User's Manual 67. Configuration Parameters Reference
Version 6.8 933 Mediant 500L MSBR
67.10.5.13 ISDN BRI Parameters
The automatic dialing upon off-hook parameters are described in the table below.
Table 67-54: Automatic Dialing Parameters
Parameter Description
BRI-to-SIP Supplementary Services Codes for Call Forward
Note: Upon receipt of an ISDN Facility message for call forward from the BRI phone, the device
sends a SIP INVITE to the softswitch with a user-defined code in the SIP To header, representing the
reason for the call forward. For more information on BRI call forwarding, see ''BRI Call Forwarding''
on
page 442.
Web/EMS: Call Forward
Unconditional
[SuppServCodeCFU]
Defines the prefix code for activating Call Forward Unconditional sent
to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Web/EMS: Call Forward
Unconditional Deactivation
[SuppServCodeCFUDeact]
Defines the prefix code for deactivating Call Forward Unconditional
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Web: Call Forward on Busy
EMS: Code Call Forward on
Busy
[SuppServCodeCFB]
Defines the prefix code for activating Call Forward on Busy sent to
the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Web: Call Forward on Busy
Deactivation
EMS: Code Call Forward on
Busy Deactivation
[SuppServCodeCFBDeact]
Defines the prefix code for deactivating Call Forward on Busy
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Web: Call Forward on No
Reply
EMS: Code Call Forward on
No Reply
[SuppServCodeCFNR]
Defines the prefix code for activating Call Forward on No Reply sent
to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward on No Reply
Deactivation
EMS: Code Call Forward on
No Reply Deactivation
[SuppServCodeCFNRDeact]
Defines the prefix code for deactivating Call Forward on No Reply
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
use-facility-in-req
[UseFacilityInRequest]
Enables the device to indicate the type of call forwarding service in
the Request-URI of the outgoing SIP INVITE message, using a
proprietary header parameter "facility=<call forward service>".
 [0] = (Default) Disable
 [1] = Enable