AudioCodes Mediant 500L MSBR

User's Manual 67. Configuration Parameters Reference
Version 6.8 1025 Mediant 500L MSBR
67.13 IP Media Parameters
The IP media parameters are described in the table below.
Table 67-72: IP Media Parameters
Parameter Description
Energy Detector Parameters
Enable Energy Detector
CLI: energy-detector-enable
[EnableEnergyDetector]
Enables the Energy Detector feature. This feature generates events
(notifications) when the signal received from the PSTN is higher or
lower than a user-defined threshold (defined by the
EnergyDetectorThreshold parameter).
 [0] Disable (default)
 [1] Enable
Energy Detector Quality
Factor
CLI: energy-detector-
sensitivity
[EnergyDetectorQualityFactor]
Defines the Energy Detector's sensitivity level.
The valid range is 0 to 10, where 0 is the lowest sensitivity and 10
the highest sensitivity. The default is 4.
Energy Detector Threshold
CLI: energy-detector-
threshold
[EnergyDetectorThreshold]
Defines the Energy Detector's threshold. A signal below or above this
threshold invokes an 'Above' or 'Below' event.
The threshold is calculated as follows:
Actual Threshold = -44 dBm + (EnergyDetectorThreshold * 6)
The valid value range is 0 to 7. The default is 3 (i.e., -26 dBm).