User's Manual 9. CLI-Based Management
Version 6.8 85 Mediant 500L MSBR
9.7 Configuring Displayed Output Lines in CLI Terminal
Window
You can configure the maximum number of lines (height) displayed in the terminal window
for the output of CLI commands (Telnet and SSH). The number of displayed lines can be
specified from 0 to 65,535, or determined by re-sizing the terminal window by mouse-
dragging the window's border.
To configure a specific number of output lines:
(config-system)# cli-terminal
<cli-terminal># window-height [0-65535]
If window-height is set to 0, the entire command output is displayed. In other words, even if
the output extends beyond the visible terminal window length, the --MORE-- prompt is not
displayed.
To configure the number of lines according to dragged terminal window:
(config-system)# cli-terminal
<cli-terminal># window-height automatic
When this mode is configured, each time you change the height of the terminal window
using your mouse (i.e., dragging one of the window's borders or corners), the number of
displayed output command lines is changed accordingly.
To Next Page
Loading...
