AudioCodes Mediant 500L MSBR

User's Manual 930 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
(Active/Idle) to the PSTN side during Cut Through mode.
 This feature can also be configured in a Tel Profile and therefore,
assigned to specific B-channels that use specific CAS tables.
67.10.5.11 Automatic Dialing Parameters
The automatic dialing upon off-hook parameters are described in the table below.
Table 67-52: Automatic Dialing Parameters
Parameter Description
Automatic Dialing Table
Web: Automatic Dialing
Table
EMS: Analog Gateway
Provisioning >
Automatic dialing
CLI: configure voip/gw
analoggw automatic-
dialing
[TargetOfChannel]
This table parameter defines telephone numbers that are automatically
dialed when a specific FXS or FXO port is off-hooked. The format of the ini
file table parameter is as follows:
[TargetOfChannel]
FORMAT TargetOfChannel_Index = TargetOfChannel_Destination,
TargetOfChannel_Type, TargetOfChannel_Module,
TargetOfChannel_Port, TargetOfChannel_HotLineToneDuration;
[\TargetOfChannel]
For example, the below configuration defines automatic dialing of phone
number 911 when the phone connected to Port 1 of Module 1 is off-
hooked
for over 10 seconds:
TargetOfChannel 0 = 911, 1, 1, 1 ,10;
Notes:
 The first index of this table ini file parameter is 0.
 TargetOfChannel_Module is the module number, where 1 denotes the
module in Slot 1.
 TargetOfChannel_Port is the port number, where 1 denotes Port 1 on
the module.
 This is parameter is applicable only to FXS and FXO interfaces.
 For a detailed description of this table, see ''Configuring Automatic
Dialing'' on page 490.
67.10.5.12 Direct Inward Dialing Parameters
The Direct Inward Dialing (DID) parameters are described in the table below.
Table 67-53: DID Parameters
Parameter Description
Web/EMS: DID Wink
CLI: did-wink-enbl
[EnableDIDWink]
Enables Direct Inward Dialing (DID) using Wink-Start signaling, typically
used for signaling between an E-911 switch and the PSAP.
 [0] Disable (default)
 [1] Single = The device can be used for connection to EIA/TIA-464B
DID Loop Start lines. Both FXO (detection) and FXS (generation) are
supported:

The FXO interface dials DTMF (or MF) digits upon detection of a
Wink signal, instead of a dial tone.

The FXS interface generates a Wink signal upon detection of an
off-hook state, instead of playing a dial tone.