User's Manual 94 Document #: LTRT-10466
Mediant 500L MSBR
Note: Only row entries whose corresponding check boxes are selected are applied
when clicking Submit; otherwise, settings revert to their defaults.
Table 10-2: SNMP Trap Destinations Parameters Description
Parameter Description
Web: SNMP Manager
[SNMPManagerIsUsed_x]
Enables the SNMP Manager to receive traps and checks
the validity of the configured destination (IP address and
port number).
[0] (check box cleared) = (Default) Disables SNMP
Manager
(check box selected) = Enables SNMP Manager
Web: IP Address
[SNMPManagerTableIP_x]
Defines the IP address (in dotted-decimal notation, e.g.,
108.10.1.255) of the remote host used as the SNMP
Manager. The device sends SNMP traps to this IP
address.
Trap Port
[SNMPManagerTrapPort_x]
Defines the port number of the remote SNMP Manager.
The device sends SNMP traps to this port.
The valid value range is 100 to 4000. The default is 162.
Web: Trap User
[SNMPManagerTrapUser]
Associates a trap user with the trap destination. This
determines the trap format, authentication level, and
encryption level.
v2cParams (default) = SNMPv2 user community string
SNMPv3 user configured in ''Configuring SNMP V3
Users'' on page 96
Trap Enable
[SNMPManagerTrapSendingEnable_x]
Activates the sending of traps to the SNMP Manager.
[0] Disable
[1] Enable (Default)
10.3 Configuring SNMP Trusted Managers
The SNMP Trusted Managers table lets you configure up to five SNMP Trusted Managers
based on IP addresses. By default, the SNMP agent accepts SNMP Get and Set requests
from any IP address as long as the correct community string is used in the request.
Security can be enhanced by using Trusted Managers, which is an IP address from which
the SNMP agent accepts and processes SNMP requests.
The following procedure describes how to configure SNMP trusted managers in the Web
interface. You can also configure this using the table ini file parameter,
SNMPTrustedMgr_x or CLI command, configure system > snmp > trusted-managers.
To Next Page
Loading...
