User's Manual 44. Disabling Analog Ports
Version 6.8 611 Mediant 500L MSBR
44 Disabling Analog Ports
You can disable an analog port (FXS or FXO) on the device. When disabled, the port
cannot be used and no signaling is transmitted through the port. By default, all the analog
ports are enabled.
To disable an analog port, use the following CLI command:
(config-voip)# interface fxs-fxo
(fxs-fxo)# analog-port-enable <module>/<port> [on|off]
For example, to disable port 2 on module 1:
(fxs-fxo)# analog-port-enable 1/2 off
To Next Page
Loading...
