AudioCodes Mediant 500L MSBR

User's Manual 67. Configuration Parameters Reference
Version 6.8 939 Mediant 500L MSBR
67.10.6.3 CAS Parameters
The Common Channel Associated (CAS) parameters are described in the table below.
Note that CAS is not applicable to BRI interfaces.
Table 67-57: CAS Parameters
Parameter Description
Web: CAS Transport Type
EMS: CAS Relay Transport Mode
CLI: CAS-transport-type
[CASTransportType]
Determines the ABCD signaling transport type over IP.
 [0] CAS Events Only = (Default) Disable CAS relay.
 [1] CAS RFC2833 Relay = Enable CAS relay mode using
RFC 2833.
[CASAddressingDelimiters]
Enables the addition of delimiters to the received address or
received ANI digits string.
 [0] = (default) Disable. The address and ANI strings remain
without delimiters.
 [1] = Enable. Delimiters such as '*', '#', and 'ST' are added to
the received address or received ANI digits string.
CLI: cas-delimiters-types
[CASDelimitersPaddingUsage]
Defines the digits string delimiter padding usage per trunk.
 [0] = (Default) Default address string padding: '*XXX#' (where
XXX is the digit string that begins with '*' and ends with '#',
when using padding).
 [1] = Special use of asterisks delimiters: '*XXX*YYY*' (where
XXX is the address, YYY is the source phone number, and '*'
is the only delimiter padding).
Note: For this parameter to take effect, a device reset is required.
Web: CAS Table per Trunk
EMS: Trunk CAS Table Index
CLI: cas-table-index
[CASTableIndex_x]
Defines the CAS protocol per trunk from a list of CAS protocols
defined by the parameter CASFileName_x.
For example, the below configuration specifies Trunks 0 and 1 to
use the E&M Winkstart CAS (E_M_WinkTable.dat) protocol, and
Trunks 2 and 3 to use the E&M Immediate Start CAS
(E_M_ImmediateTable.dat) protocol:
CASFileName_0 = 'E_M_WinkTable.dat'
CASFileName_1 = 'E_M_ImmediateTable.dat'
CASTableIndex_0 = 0
CASTableIndex_1 = 0
CASTableIndex_2 = 1
CASTableIndex_3 = 1
Notes:
 You can define CAS tables per B-
channel using the parameter
CASChannelIndex.
 The x
in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Web: Dial Plan
EMS: Dial Plan Name
CLI: cas-dial-plan-name
[CASTrunkDialPlanName_x]
Defines the CAS Dial Plan name per trunk.
The range is up to 11 characters.
For example, the below configures E1_MFCR2 trunk with a single
protocol (Trunk 5):
ProtocolType_5 = 7
CASFileName_0='R2_Korea_CP_ANI.dat'
CASTableIndex_5 = 0
DialPlanFileName = 'DialPlan_USA.dat'
CASTrunkDialPlanName_5 = 'AT_T'