AudioCodes Mediant 500L MSBR

User's Manual 1032 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
Management LDAP Groups Table
Web: Management LDAP Groups Table
CLI: configure voip > ldap > mgmt-ldap-
groups
[MgmntLDAPGroups]
Defines the users group attribute in the AD and
corresponding management access level.
[ MgmntLDAPGroups ]
FORMAT MgmntLDAPGroups_Index =
MgmntLDAPGroups_LdapConfigurationIndex,
MgmntLDAPGroups_GroupIndex,
MgmntLDAPGroups_Level, MgmntLDAPGroups_Group;
[ \MgmntLDAPGroups ]
For a detailed description of this table, see ''Configuring
Access Level per Management Groups Attributes''
on page
233.
67.14.3 Least Cost Routing Parameters
The Least Cost Routing (LCR) parameters are described in the table below.
Table 67-77: LCR Parameters
Parameter Description
Web: Routing Rule Groups
Table
CLI: configure voip >
services least-cost-routing
routing-rule-groups
[RoutingRuleGroups]
This table parameter enables the LCR feature and configures the
average call duration and default call cost. The default call cost
determines whether routing rules that are not configured with a Cost
Group are considered as a higher or lower cost route compared to
other matching routing rules that are assigned Cost Groups.
[ RoutingRuleGroups ]
FORMAT RoutingRuleGroups_Index =
RoutingRuleGroups_LCREnable,
RoutingRuleGroups_LCRAverageCallLength,
RoutingRuleGroups_LCRDefaultCost;
[ \RoutingRuleGroups ]
Note: For a detailed description of this table, see ''Enabling LCR and
Configuring Default LCR'' on page 251.
Web: Cost Group Table
EMS: Cost Group
Provisioning > Cost Group
CLI: configure voip >
services least-cost-routing
cost-group
[CostGroupTable]
This table parameter configures the Cost Groups for LCR, where each
Cost Group is configured with a name, fixed call connection charge,
and a call rate (charge per minute).
[ CostGroupTable ]
FORMAT CostGroupTable_Index =
CostGroupTable_CostGroupName,
CostGroupTable_DefaultConnectionCost,
CostGroupTable_DefaultMinuteCost;
[ \CostGroupTable ]
For example: CostGroupTable 2 = "Local Calls", 2, 1;
Note: For a detailed description of this table, see ''Configuring Cost
Groups'' on page 253.