AudioCodes Mediant 500L MSBR

User's Manual 67. Configuration Parameters Reference
Version 6.8 801 Mediant 500L MSBR
Parameter Description
[SRV2IP]
and port. The format of this parameter is as follows:
[SRV2IP]
FORMAT SRV2IP_Index = SRV2IP_InternalDomain,
SRV2IP_TransportType, SRV2IP_Dns1, SRV2IP_Priority1,
SRV2IP_Weight1, SRV2IP_Port1, SRV2IP_Dns2, SRV2IP_Priority2,
SRV2IP_Weight2, SRV2IP_Port2, SRV2IP_Dns3, SRV2IP_Priority3,
SRV2IP_Weight3, SRV2IP_Port3;
[\SRV2IP]
For example:
SRV2IP 0 =
SrvDomain,0,Dnsname1,1,1,500,Dnsname2,2,2,501,$$,0,0,0;
For a detailed description of this table, see ''Configuring the Internal SRV
Table'' on page 154.
67.2.6 DHCP Parameters
The Dynamic Host Control Protocol (DHCP) parameters are described in the table below.
Table 67-15: DHCP Parameters
Parameter Description
Web: Enable DHCP
EMS: DHCP Enable
[DHCPEnable]
Enables DHCP client functionality.
 [0] Disable (default)
 [1] Enable
Notes:
 For this parameter to take effect, a device reset is required.
 For a detailed description of DHCP, see ''DHCP-based Provisioning''
on page 647.
 This parameter is a "hidden" parameter. Once defined and saved to
flash memory, its value doesn't revert to default even if the parameter
doesn't appear in the ini file.
EMS: DHCP Speed Factor
[DHCPSpeedFactor]
Defines the device's DHCP renewal speed for a leased IP address from
a DHCP server.
 [0] = Disable
 [1] = (Default) Normal
 [2] to [10] = Fast
When set to 0, the DHCP lease renewal is disabled. Otherwise, the
renewal time is divided by this factor. Some DHCP-enabled routers
perform better when set to 4.
Note: For this parameter to take effect, a device reset is required.