AudioCodes Mediant 500L MSBR

User's Manual 18. Services
Version 6.8 255 Mediant 500L MSBR
Parameter Description
[CostGroupTimebands_TimebandIndex]
index.
Start Time
CLI: start-time
[CostGroupTimebands_StartTime]
Defines the day and time of day from when this time
band is applicable. The format is DDD:hh:mm, where:
 DDD is the day of the week, represented by the first
three letters of the day in upper case (i.e., SUN,
MON, TUE, WED, THU, FRI, or SAT).
 hh and mm denote the time of day, where hh is the
hour (00-23) and mm the minutes (00-59)
For example, SAT:22:00 denotes Saturday at 10 pm.
End Time
CLI: end-time
[CostGroupTimebands_EndTime]
Defines the day and time of day until when this time
band is applicable. For a description of the valid values,
see the parameter above.
Connection Cost
CLI: connection-cost
[CostGroupTimebands_ConnectionCost]
Defines the call connection cost during this time band.
This is added as a fixed charge to the call.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e.,
not a decimal).
Minute Cost
CLI: minute-cost
[CostGroupTimebands_MinuteCost]
Defines the call cost per minute charge during this
timeband.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e.,
not a decimal).
18.5.2.4 Assigning Cost Groups to Routing Rules
To use your configured Cost Groups, you need to assign them to routing rules:

Gateway application: Outbound IP Routing table - see Configuring Outbound IP
Routing on page
405

SBC application: IP-to-IP Routing table - see Configuring SBC IP-to-IP Routing Rules
on page
564