User's Manual 900 Document #: LTRT-10466
Mediant 500L MSBR
67.10.4 Voice Mail Parameters
The voice mail parameters are described in the table below. For more information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Table 67-41: Voice Mail Parameters
Parameter Description
Web/EMS: Voice Mail
Interface
CLI: vm-interface
[VoiceMailInterface]
Enables the device's Voice Mail application and determines the
communication method between the device and PBX.
[0] None (default)
[1] DTMF
[2] SMDI
[3] QSIG
[4] SETUP Only = Applicable only to ISDN.
[5] MATRA/AASTRA QSIG
[6] QSIG SIEMENS = QSIG MWI activate and deactivate
messages include Siemens Manufacturer Specific Information
(MSI)
[7] IP2IP = The device's IP-to-
IP application is used for interworking
between an IP Voice Mail server and the device. This is
implemented for sending unsolicited SIP NOTIFY messages
received from the Voice Mail server to an IP Group (configured
using the NotificationIPGroupID parameter).
[8] ETSI = Euro ISDN, according to ETS 300 745-1 V1.2.4, section
9.5.1.1. Enables MWI interworking from IP to Tel, typically used for
BRI phones.
[9] = ISDN PRI trunks set to NI-2. This is used for interworking the
SIP Message Waiting Indication (MWI) NOTIFY message to ISDN
PRI NI-2 Message Waiting Notification (MWN) that is sent in the
ISDN Facility IE message. This option is applicable when the
device is connected to a PBX through an ISDN PRI trunk
configured to NI-2.
Note: To disable voice mail per Trunk Group, you can use a Tel
Profile with the EnableVoiceMailDelay parameter set to disabled (0).
This eliminates the phenomenon of call delay on Trunks not
implementing voice mail when voice mail is enabled using this global
parameter.
Web: Enable VoiceMail URI
EMS: Enable VMURI
CLI: voicemail-uri
[EnableVMURI]
Enables the interworking of target and cause for redi
IP and vice versa, according to RFC 4468.
[0] Disable (default)
[1] Enable
Upon receipt of an ISDN Setup message with Redirect values, the
device maps the Redirect phone number to the SIP 'target' parameter
and the Redirect number reason to the SIP 'cause' parameter in the
Request-URI.
Redirecting Reason >> SIP Response Code
Unknown >> 404
User busy >> 486
No reply >> 408
Deflection >> 487/480
Unconditional >> 302
Others >> 302
If the device receives a Request-URI that includes a 'target' and
To Next Page
Loading...
