AudioCodes Mediant 500L MSBR

User's Manual 878 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description

[3] = 3 dB
EMS: ECN lp Mode
CLI: echo-canceller-NLP-
mode
[ECNLPMode]
Defines the echo cancellation Non-Linear Processing (NLP) mode.
 [0] = (Default) NLP adapts according to echo changes
 [1] = Disables NLP
 [2] = Silence output NLP
Note: This parameter can also be configured in a Tel Profile.
CLI: echo-canceller-
aggressive-NLP
[EchoCancellerAggressiveN
LP]
Enables the Aggressive NLP at the first 0.5 second of the call.
 [0] = Disable
 [1] = (Default) Enable. The echo is removed only in the first half
of a second of the incoming IP signal.
Note: For this parameter to take effect, a device reset is required.
CLI: number-of-SID-
coefficients
[RTPSIDCoeffNum]
Defines the number of spectral coefficients added to an SID packet
being sent according to RFC 3389.
The valid values are [0] (default), [4], [6], [8] and [10].
Answer Detector (AD) Parameters
Web: Enable Answer Detector
[EnableAnswerDetector]
Currently, not supported.
Web: Answer Detector Activity
Delay
CLI: answer-detector-
activativity-delay
[AnswerDetectorActivityDel
ay]
Defines the time (in 100-msec resolution) between activating the
Answer Detector and the time that the detector actually starts to
operate.
The valid range is 0 to 1023. The default is 0.
Web: Answer Detector Silence
Time
[AnswerDetectorSilenceTim
e]
Currently, not supported.
Web: Answer Detector
Redirection
[AnswerDetectorRedirection
]
Currently, not supported.
Web: Answer Detector
Sensitivity
EMS: Sensitivity
CLI: answer-detector-
sensitivity
[AnswerDetectorSensitivity]
Defines the Answer Detector sensitivity.
The range is 0 (most sensitive) to 2 (least sensitive). The default is 0.
67.9.2 Coder Parameters
The coder parameters are described in the table below.
Table 67-35: Coder Parameters
Parameter Description
Silk Tx Inband FEC
CLI: silk-tx-inband-fec
Enables forward error correction (FEC) for the SILK coder.
 [0] Disable (default)