User's Manual 968 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
[CurrentDisconnectDefaultThreshold] Defines the line voltage threshold at which a current
disconnect detection is considered.
The valid range is 0 to 20 Volts. The default is 4 Volts.
Notes:
This parameter is applicable only to FXO interfaces.
For this parameter to take effect, a device reset is
required.
CLI: time-to-sample-analog-line-voltage
[TimeToSampleAnalogLineVoltage]
Defines the frequency at which the analog line voltage is
sampled (after offhook), for detection of the current
disconnect threshold.
The valid range is 100 to 2500 msec. The default is 1000
msec.
Notes:
This parameter is applicable only to FXO interfaces.
For this parameter to take effect, a device reset is
required.
67.10.9 Tone Parameters
This subsection describes the device's tone parameters.
67.10.9.1 Telephony Tone Parameters
The telephony tone parameters are described in the table below.
Table 67-61: Tone Parameters
Parameter Description
Web: SIP Hold Behavior
CLI: sip-hold-behavior
[SIPHoldBehavior]
Enables the device to handle incoming re-INVITE messages with the
"a=sendonly" attribute in the SDP, in the same way as if an
"a=inactive" is received in the SDP. When enabled, the device plays a
held tone to the Tel phone and responds with a SIP 200 OK containing
the "a=recvonly" attribute in the SDP.
[0] Disable (default)
[1] Enable
Web/EMS: Dial Tone
Duration [sec]
CLI: dt-duration
[TimeForDialTone]
Defines the duration (in seconds) that the dial tone is played
interfaces, to an ISDN terminal).
For digital interfaces: This parameter is applicable for overlap dialing
when ISDNInCallsBehavior is set to 65536. The dial tone is played if
the ISDN Setup message doesn't include the called number.
The valid range is 0 to 60. The default is 5.
For analog interfaces: FXS interfaces play the dial tone after the
phone is picked up (off-hook). FXO interfaces play the dial tone after
the port is seized in response to ringing (from PBX/PSTN).
The valid range is 0 to 60. The default time is 16.
Notes for analog interfaces:
During play of dial tone, the device waits for DTMF digits.
This parameter is not applicable when Automatic Dialing is
enabled.
Defines the duration (in msec) of the confirmation tone. A stutter tone
To Next Page
Loading...
