AudioCodes Mediant 500L MSBR

User's Manual 67. Configuration Parameters Reference
Version 6.8 813 Mediant 500L MSBR
67.3.5 PacketSmart Parameters
The PacketSmart parameters are described in the table below. For more information on
PacketSmart, see 'Configuring PacketSmart for Network Monitoring' on page 684.
PacketSmart Parameters
Parameter Description
PacketSmart Agent Mode
configure system >
packetsmart enable
[PacketSmartAgentMode]
Enables the embedded PacketSmart agent.
 [0] Disable (Default)
 [1] Enable
Note: For the parameter to take effect, a device reset is required.
PacketSmart IP Address
configure system >
packetsmart server
address
[PacketSmartIpAddress]
Defines the IP address of the PacketSmart server with which the
PacketSmart agent communicates.
The default is 0.0.0.0.
PacketSmart IP Address
Port
configure system >
packetsmart server
address port
[PacketSmartIpAddressP
ort]
Defines the TCP port of the PacketSmart server to which the
PacketSmart agent connects.
The default is 80.
Monitoring Interface
configure system >
packetsmart monitor
voip interface-if
[PacketSmartMonitorInterf
ace]
Assigns an IP network interface (configured in the IP Interface table)
that handles the voice traffic.
Note: For the parameter to take effect, a device reset is required.
Network Interface
configure system >
packetsmart network
voip interface-if
[PacketSmartNetworkInter
face ]
Assigns an IP network interface (configured in the IP Interface table) for
communicating with the PacketSmart server. This is typically the OAMP
interface.
Note: For the parameter to take effect, a device reset is required.