User's Manual 800 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
Incoming Packet Mechanism'' on page 161.
Web: NAT IP Address
EMS: Static NAT IP
Address
CLI: nat-ip-addr
[StaticNatIP]
Defines the global (public) IP address of the device to enable static NAT
between the device and the Internet.
Note: For this parameter to take effect, a device reset is required.
Web: SIP NAT Detection
CLI: configure voip/sip-
definition advanced-
settings/sip-nat-detect
[SIPNatDetection]
Enables the device to detect whether the incoming INVITE message is
sent from an endpoint located behind NAT.
[0] Disable = Disables the device's NAT Detection mechanism.
Incoming SIP messages are processed as received from endpoints
that are not located behind NAT and sent according to the SIP
standard.
[1] Enable (default) = Enables the device's NAT Detection
mechanism.
EMS: Binding Life Time
[NATBindingDefaultTime
out]
The device sends SNMP keep-alive traps periodically - every 9/10 of the
time configured by this parameter (in seconds). Therefore, the
parameter is applicable only if the SendKeepAliveTrap parameter is set
to 1.
The parameter is used to allow SNMP communication with AudioCodes
EMS management platform, located in the WAN, when the device is
located behind NAT. It is needed to keep the NAT pinhole open for the
SNMP messages sent from EMS to the device.
The valid range is 0 to 2,592,000. The default is 30.
Note: For this parameter to take effect, a device reset is required.
67.2.5 DNS Parameters
The Domain name System (DNS) parameters are described in the table below.
Table 67-14: DNS Parameters
Parameter Description
Internal DNS Table
Web: Internal DNS Table
EMS: DNS Information
CLI: configure voip > voip-
network dns Dns2Ip
[DNS2IP]
This table parameter defines the internal DNS table for resolving host
names into IP addresses.
The format of this parameter is as follows:
[Dns2Ip]
FORMAT Dns2Ip_Index = Dns2Ip_DomainName,
Dns2Ip_FirstIpAddress, Dns2Ip_SecondIpAddress,
Dns2Ip_ThirdIpAddress, Dns2Ip_FourthIpAddress;
[\Dns2Ip]
For example:
Dns2Ip 0 = DnsName, 1.1.1.1, 2.2.2.2, 3.3.3.3, ;
For a detailed description of this table, see ''Configuring the Internal DNS
Table'' on page 153.
Internal SRV Table
Web: Internal SRV Table
EMS: DNS Information
CLI: configure voip > voip-
This table parameter defines the internal SRV table for resolving host
names into DNS A-Records. Three different A-Records can be assigned
to a host name. Each A-Record contains the host name, priority, weight,
To Next Page
Loading...
