AudioCodes Mediant 500L MSBR

User's Manual 67. Configuration Parameters Reference
Version 6.8 779 Mediant 500L MSBR
67 Configuration Parameters Reference
The device's VoIP functionality (not data-routing functionality) configuration parameters,
default values, and their descriptions are documented in this section.
Note: Parameters and values enclosed in square brackets [...] represent the ini file
parameters and their enumeration values.
67.1 Management Parameters
This section describes the device's management-related parameters.
67.1.1 General Parameters
The general management parameters are described in the table below.
Table 67-1: General Management Parameters
Parameter Description
WAN OAMP Interface
CLI: bind GigabitEthernet
<slot/port.vlanId> oamp
[OAMPWanInterfaceName]
Binds the OAMP interface to a WAN interface, which can later be
associated with a Virtual Routing and Forwarding (VRF).
Web: Allow WAN access to
HTTP
CLI: wan-http-allow
[AllowWanHTTP]
Enables WAN access to the management interface through HTTP.
 [0] Disable (default)
 [1] Enable
 By default, the device's data-router firewall blocks all ("any")
incoming traffic on the WAN. Thus, to enable WAN access, you must
also enable the data-router firewall:
# configure data
(config-data)# interface gigabitethernet 0/0
(conf-if-GE 0/0)# firewall enable
Web: Allow WAN access to
HTTPS
CLI: wan-https-allow
[AllowWanHTTPS]
Enables WAN access to the management interface through HTTPS.
 [0] Disable (default)
 [1] Enable
 By default, the device's data-router firewall blocks all ("any")
incoming traffic on the WAN. Thus, to enable WAN access, you must
also enable the data-router firewall:
# configure data
(config-data)# interface gigabitethernet 0/0
(conf-if-GE 0/0)# firewall enable