User's Manual 63. Data-Router Debugging
Version 6.8 769 Mediant 500L MSBR
63 Data-Router Debugging
63.1 Loopback on WAN Interface Debugging
You can perform loopback testing on the WAN interface for debugging purposes. Loopback
debugging can be activated on any WAN interface (name or type).
To perform loopback testing, use the following CLI command:
# debug ethernet loopback interface <interface name / type>
For example:
# debug ethernet loopback interface GigabitEthernet 0/0
The no debug command disables the loopback test.
Note: All communication through the loopback WAN interface stops when this test is
enabled.
To Next Page
Loading...
