AudioCodes Mediant 500L MSBR

User's Manual 932 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
Web/EMS: Delay Before
DID Wink
CLI: delay-b4-did-wink
[DelayBeforeDIDWink]
Defines the time interval (in msec) between the detection of the off-hook
and the generation of the DID Wink.
The valid range is 0 to 1,000. The default is 0.
Note: This parameter is applicable only to FXS interfaces.
EMS: NTT DID Signalling
Form
CLI: NTT-DID-signaling-
form
[NTTDIDSignallingForm]
Determines the type of DID signaling support for NTT (Japan) modem:
DTMF- or Frequency Shift Keying (FSK)-based signaling. The devices
can be connected to Japan's NTT PBX using 'Modem' DID lines. These
DID lines are used to deliver a called number to the PBX.
 [0] = (Default) FSK-based signaling
 [1] = DTMF-based signaling
Note: This parameter is applicable only to FXS interfaces.
EMS: Enable DID
[EnableDID]
This table parameter enables support for Japan NTT 'Modem' DID. FXS
interfaces can be connected to Japan's NTT PBX using 'Modem' DID
lines. These DID lines are used to deliver a called number to the PBX.
The DID signal can be sent alone or combined with an NTT Caller ID
signal.
The format of the ini file table parameter is as follows:
[EnableDID]
FORMAT EnableDID_Index = EnableDID_IsEnable, EnableDID_Port,
EnableDID_Module;
[\EnableDID]
Where,
 IsEnable = Enables [1] or disables [0] (default) Japan NTT Modem
DID support.
 Port = Port number.
 Module = Module number.
For example:
EnableDID 0 = 1,1,2; (DID is enabled on Port 1 of Module 2)
Note: This parameter is applicable only to FXS interfaces.
CLI: wink-time
[WinkTime]
Defines the time (in msec) elapsed between two consecutive polarity
reversals. This parameter can be used for DID signaling, for example,
E911 lines to the Public Safety Answering Point (PSAP), according to the
Bellcore GR-350-CORE standard (refer to the ini file parameter
Enable911PSAP).
The valid range is 0 to 4,294,967,295. The default is 200.
Notes:
 This parameter is applicable to FXS and FXO interfaces.
 For this parameter to take effect, a device reset is required.