User's Manual 102 Document #: LTRT-10466
Mediant 500L MSBR
The CPE responds to the Download method, indicating successful or
unsuccessful completion via one of the following:
♦ A DownloadResponse with the Status argument set to zero (indicating
success), or a fault response to the Download request (indicating failure).
♦ A TransferComplete message sent later in the same session as the
Download request (indicating either success or failure). In this case, the
Status argument in the corresponding DownloadResponse has a value of
one.
♦ A TransferComplete message sent in a subsequent session (indicating
success or failure). In this case, the Status argument in the corresponding
DownloadResponse has a value of one.
Figure 11-3: Download Method Executuion Example
• Upload: Used by the ACS to cause the CPE to upload (to the ACS) the following
files to a designated location:
♦ Vendor Configuration File (File Type = 1 or 3): Output of show running-
config CLI command, which includes Data and Voice configuration. For
File Type 3 (where index is included – see below) only one instance of the
file is supported.
To Next Page
Loading...
