AudioCodes Mediant 500L MSBR

User's Manual 13. Configuring SSL/TLS Certificates
Version 6.8 119 Mediant 500L MSBR
 To configure a TLS Context:
1. Open the TLS Contexts page (Configuration tab > System menu > TLS Contexts).
2. Click Add; the following dialog box appears:
Figure 13-1: TLS Contexts Table - Add Record Dialog Box
3. Configure the TLS Context according to the parameters described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 13-1: TLS Context Parameter Descriptions
Parameter Description
Web: Index
CLI: tls <ID>
[TLSContexts_Index]
Defines an index number for the new table record.
Note: Each table row must be configured with a unique
index.
Web: Name
CLI: name
[TLSContexts_Name]
Defines an arbitrary name to easily identify the TLS
Context.
The valid value is a string of up to 31 characters.
Web: Version
CLI: tls-version
[TLSContexts_TLSVersion]
Defines the supported SSL/TLS protocol version. Clients
attempting to communicate with the device using a TLS
version that is not configured are rejected.
 [0] 0 = (Default) SSL 3.0 and all TLS versions are
supported. SSL/TLS handshakes always start with an
SSL 2.0-compatible handshake and then switch to the
highest TLS version supported by both peers.
 [1] 1 = TLS 1.0 only.
 [2] 2 = TLS 1.1 only.
 [3] 3 = TLS 1.1 and TLS 1.0 only.
 [4] 4 = TLS 1.2 only.
 [5] 5 = TLS 1.2 and TLS 1.0 only.
 [6] 6 = TLS 1.2 and TLS 1.1 only
 [7] 7 = TLS 1.2, TLS 1.1 and TLS 1.0 only (excludes
SSL 3.0).