AudioCodes Mediant 500L MSBR

User's Manual 20. Control Network
Version 6.8 285 Mediant 500L MSBR
Parameter Description
SRD
CLI: srd
[SIPInterface_SRD]
Assigns an SRD ID to the SIP Interface (configured in
''Configuring SRDs'' on page 280).
The default is 0.
Notes:
 You can assign the same SRD ID to up to two SIP
Interfaces of the same application type.
 For the SAS application, use only SRD ID 0.
 Each SIP Interface of the same application type (e.g.,
SBC) that is assigned to the same SRD must be
configured with the same IP version (IPv4 or IPv6).
 All the SIP Interfaces that are assigned to the same SRD
must have the same network interface (assigned in the
'Network Interface' parameter, above).
Message Policy
CLI: message-policy
[SIPInterface_MessagePolicy]
Assigns a SIP message policy to the SIP interface
(configured in ''Configuring SIP Message Policy Rules'').
TLS Context Name
CLI: tls-context-name
[SIPInterface_TLSContext]
Assigns a TLS Context (SSL/TLS certificate) to the SIP
Interface. The TLS Context is assigned by name, as
configured in the 'Name' field of the TLS Contexts table.
 Incoming calls: This TLS Context is used if no TLS
Context is configured for the Proxy Set associated with
the call or classification to an IP Group based on Proxy
Set fails.
 Outgoing calls: This TLS Context is used if no TLS
Context is configured for the Proxy Set associated with
the call.
For more information about how certificates are associated
with calls and for configuring TLS Contexts, see ''Configuring
SSL/TLS Certificates'' on page 117.
TLS Mutual Authentication
CLI: tls-mutual-auth
[SIPInterface_TLSMutualAuthentica
tion]
Enables TLS mutual authentication for the SIP Interface
(when device acts as a server).
 [-1] Not Configured = (Default) The
SIPSRequireClientCertificate global parameter setting is
applied.
 [0]
Disable = Device does not request the client certificate
for TLS connection on this SIP Interface.
 [1] Enable = Device requires receipt and verification of
the client certificate to establish the TLS connection on
this SIP Interface.
Enable TCP Keepalive
CLI: tcp-keepalive-enable
[SIPInterface_TCPKeepaliveEnable]
Enables the TCP Keep-Alive mechanism with the IP entity
on this SIP Interface. TCP keep-alive can be used, for
example, to keep a NAT entry open for clients located
behind a NAT server, or simply to check that the connection
to the IP entity is available.
 [0] Disable (default)
 [1] Enable
Note: For configuring TCP keepalive, use the following ini
file parameters: TCPKeepAliveTime, TCPKeepAliveInterval,
and TCPKeepAliveRetry.
Classification Failure Response Type
CLI: classification_fail_response_type
Defines the SIP response code that the device sends if a
received SIP request (OPTIONS, REGISTER, or INVITE)