AudioCodes Mediant 500L MSBR

User's Manual 290 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
Note: This field is applicable only to the SBC and.
Description
CLI: description
[IPGroup_Description]
Defines a brief description for the IP Group.
The valid value is a string of up to 29 characters. The default is an
empty field.
Proxy Set ID
CLI: proxy-set-id
[IPGroup_ProxySetId]
Assigns a Proxy Set ID to the IP Group. All INVITE messages
destined to this IP Group are sent to the IP address configured for
the Proxy Set.
Notes:
 The Proxy Set is applicable only to Server-type IP Groups.
 The SRD configured for this Proxy Set in the Proxy Set table is
automatically assigned to this IP Group (see the 'SRD' field
below).
 To configure Proxy Sets, see ''Configuring Proxy Sets'' on page
297.
SIP Group Name
CLI: sip-group-name
[IPGroup_SIPGroupName]
Defines the SIP Request-
URI host name in INVITE and REGISTER
messages sent to this IP Group, or the host name in the From
header of INVITE messages received from this IP Group. In other
words, it replaces the original host name.
The valid value is a string of up to 100 characters. The default is an
empty field.
Notes:
 If this parameter is not configured, the value of the global
parameter, ProxyName is used instead (see ''Configuring Proxy
and Registration Parameters'' on page 309).
 The parameter overrides inbound message manipulation rules
that manipulate the host name in Request-URI, To, and/or From
SIP headers. If you configure the parameter and you want to
manipulate the host name in any of these SIP headers, you
must apply your manipulation rule (Manipulation Set ID) to the
IP Group as an Outbound Message Manipulation Set (see the
IPGroup_OutboundManSet parameter), when the IP Group is
the destination of the call. If you apply the Manipulation Set as
an Inbound Message Manipulation Set (see the
IPGroup_InboundManSet parameter), when the IP Group is the
source of the call, the manipulation rule is overridden by the SIP
Group Name parameter.
 If the IP Group is of User type, this parameter is used internally
as a host name in the Request-URI for Tel-to-IP initiated calls.
For example, if an incoming call from the device's T1 trunk is
routed to a User-type IP Group, the device first creates the
Request-URI (<destination_number>@<SIP Group Name>),
and then it searches the internal database for a match.
Contact User
CLI: contact-user
[IPGroup_ContactUser]
Defines the user part of the From, To, and Contact headers of SIP
REGISTER messages, and the user part of the Contact header of
INVITE messages received from this IP Group and forwarded by
the device to another IP Group.
Notes:
 This parameter is applicable only to Server-type IP Groups.
 This parameter is overridden by the ‘Contact User’ parameter in
the ‘Account’ table (see ''Configuring Registration Accounts'' on
page 305).