User's Manual 292 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
[IPGroup_QOEProfile]
of Experience Profiles, see ''Configuring Quality of Experience
Profiles'' on page 264.
Bandwidth Profile
CLI: bandwidth-profile
[IPGroup_BWProfile]
Assigns a Bandwidth Profile rule. For configuring Bandwidth
Profiles, see ''Configuring Bandwidth Profiles'' on page 268.
Media Enhancement Profile
CLI: media-enhancement-
profile
[IPGroup_MediaEnhancement
Profile]
Assigns a Media Enhancement Profile rule. For configuring Media
Enhancement Profiles, see ''Configuring Media Enhancement
Profiles'' on page 271.
Always Use Source Address
CLI: always-use-source-addr
[IPGroup_AlwaysUseSourceA
ddr]
Enables the device to always send SIP requests and responses,
within a SIP dialog, to the source IP address received in the
previous SIP message packet. This feature is especially useful in
scenarios where the IP Group endpoints are located behind a NAT
firewall (and the device is unable to identify this using its regular
NAT mechanism).
[0] No = (Default) The device sends SIP requests according to
the settings of the global parameter, SIPNatDetection.
[1] Yes = The device sends SIP requests and responses to the
source IP address received in the previous SIP message
packet.
For information on NAT traversal, see ''Remote UA behind NAT''
page 160.
CLI: Msg-Man-User-Defined-
String1
[IPGroup_MsgManUserDef1]
Defines a value for the SIP user part that can be used in Message
Manipulation rules configured in the Message Manipulations table.
The Message Manipulation rule obtains this value from the IP
Group, by using the following syntax: param.ipg.<src|dst>.user-
defined.<0>.
The valid value is a string of up to 30 characters.
For configuring Message Manipulation rules, see ''Configuring SIP
Message Manipulation'' on page 313.
CLI: Msg-Man-User-Defined-
String2
[IPGroup_MsgManUserDef2]
Defines a value for the SIP user part that can be used in Message
Manipulation rules configured in the Message Manipulations table.
The Message Manipulation rule obtains this value from the IP
Group, by using the following syntax: param.ipg.<src|dst>.user-
defined.<1>.
The valid value is a string of up to 30 characters.
For configuring Message Manipulation rules, see ''Configuring SIP
Message Manipulation'' on page 313.
Gateway Parameters
Always Use Route Table
CLI: always-use-route-table
[IPGroup_AlwaysUseRouteTabl
e]
Defines the Request-URI host name in outgoing INVITE messages.
[0] No (default).
[1] Yes = The device uses the IP address (or domain name)
defined in the Outbound IP Routing table (see Configuring the
Outbound IP Routing on page 405) as the Request-URI host
name in outgoing INVITE messages, instead of the value
configured in the 'SIP Group Name' field.
Note: This parameter is applicable only to Server-type IP Groups.
SIP Re-Routing Mode
Defines the routing mode after a call redirection (i.e., a 3xx SIP
response is received) or transfer (i.e., a SIP REFER request is
To Next Page
Loading...
