AudioCodes Mediant 500L MSBR

User's Manual 294 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
security. When classification is based on Proxy Set, the
Classification table for the specific IP Group is ignored.
 If you have assigned the same Proxy Set to multiple IP Groups,
disable the parameter and instead, use Classification rules to
classify incoming SIP dialogs to these IP Groups. If the
parameter is enabled, the device is unable to correctly classify
incoming INVITEs to their appropriate IP Groups.
 Classification by Proxy Set occurs only if classification based on
the device's registration database fails (i.e., the INVITE is not
from a registered user).
Max. Number of Registered
Users
CLI: max-num-of-reg-users
[IPGroup_MaxNumOfRegUsers
]
Defines the maximum number of users in this IP Group that can
register with the device. By default, no limitation exists for
registered users.
Note: This field is applicable only to User-type IP Groups.
Inbound Message Manipulation
Set
CLI: inbound-mesg-
manipulation-set
[IPGroup_InboundManSet]
Assigns a Message Manipulation Set (rule) to the IP Group for SIP
message manipulation on the inbound message. To configure
Message Manipulation rules, see Configuring SIP Message
Manipulation on page 313.
Note: The IPGroup_SIPGroupName parameter overrides inbound
message manipulation rules (assigned to the
IPGroup_InboundManSet parameter) that manipulate the host
name in Request-URI, To, and/or From SIP headers. If you want to
manipulate the host name using message manipulation rules in any
of these SIP headers, you must apply your manipulation rule
(Manipulation Set ID) to the IP Group as an Outbound Message
Manipulation Set (see the IPGroup_OutboundManSet parameter),
when the IP Group is the destination of the call.
Outbound Message
Manipulation Set
CLI: outbound-mesg-
manipulation-set
[IPGroup_OutboundManSet]
Assigns a Message Manipulation Set (rule) to the IP Group for SIP
message manipulation on the outbound message. To configure
Message Manipulation rules, see Configuring SIP Message
Manipulation on page 313.
Note: If you assign a Message Manipulation Set ID that includes
rules for manipulating the host name in the Request-URI, To,
and/or From SIP headers, the parameter overrides the
IPGroup_SIPGroupName parameter.
Registration Mode
CLI: registration-mode
[IPGroup_RegistrationMode]
Defines the registration mode for the IP Group:
 [0] User Initiates Registration (default)
 [1] SBC Initiates Registration = Used when the device serves as
a client (e.g., with an IP PBX). This functions only with the User
Info file.
 [2] Registrations not Needed = The device adds users to its
database in active state.
Authentication Mode
CLI: authentication-mode
[IPGroup_AuthenticationMode]
Defines the authentication mode.
 [0] User Authenticates = (Default) The device does not handle
the authentication, but simply passes the authentication
messages between the SIP user agents.
 [1] SBC as Client = The device authenticates as a client. It
receives the 401/407 response from the proxy requesting for
authentication. The device sends the proxy the authorization
credentials (i.e., username and password) according to one of
the following: 1) account defined in the Account table (only if