AudioCodes Mediant 500L MSBR

User's Manual 302 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
Web/EMS: SRD Index
CLI: voip-network proxy-set >
srd-id
[ProxySet_ProxySet_SRD]
Assigns an SRD to the Proxy Set ID.
The default is SRD 0.
Notes:
 For this parameter to take effect, a device reset is required.
 To configure SRDs, see Configuring SRDs on page 280.
Web/EMS: Classification Input
CLI: voip-network proxy-set >
classification-input
[ProxySet_ClassificationInput]
Defines how the device classifies IP calls to the Proxy Set.
 [0] IP Only = (Default) The call is classified to the Proxy Set
according to its IP address only.
 [1] IP + Port + Transport = The call is classified to the Proxy Set
according to its IP address, port, and transport type.
Notes:
 This parameter is applicable only if the IP Group table's
parameter, 'Classify by Proxy Set' is set to Enable.
 This parameter is applicable only to the SBC application.
Web/EMS: TLS Context Index
CLI: tls-context-index
[ProxySet_TLSContext]
Assigns a TLS Context (SSL/TLS certificate) to the Proxy Set. The
TLS Context is assigned by index number, as configured in the
TLS Contexts table.
 Incoming calls: If the 'Transport Type' parameter (above) is set
to TLS and the incoming call is successfully classified to an IP
Group based on this Proxy Set, this TLS Context is used. If the
'Transport Type' parameter is set to UDP or classification to this
Proxy Set fails, this TLS Context is not used. Instead, the device
uses the TLS Context configured for the SIP Interface (see
''Configuring SIP Interfaces'' on page
283) used for the call;
otherwise, the default TLS Context (ID 0) is used.
 Outgoing calls: If the 'Transport Type' parameter (above) is set
to TLS and the outgoing call is sent to an IP Group that is
associated with this Proxy Set, this TLS Context is used.
Instead, the device uses the TLS Context configured for the SIP
Interface used for the call; otherwise, the default TLS Context
(ID 0) is used. If the 'Transport Type' parameter is set to UDP,
the device uses UDP to communicate with the proxy and no
TLS Context is used.
For more information about how certificates are associated with
calls and for configuring TLS Contexts, see ''Configuring SSL/TLS
Certificates'' on page 117.