AudioCodes Mediant 500L MSBR

User's Manual 21. SIP Definitions
Version 6.8 307 Mediant 500L MSBR
Parameter Description
[Account_ServingIPGroup]

For Tel-to-IP calls, the serving IP Group is the destination IP
Group configured in the Trunk Group Settings table or Outbound
IP Routing table (see Configuring the Outbound IP Routing on
page
405).
 For IP-to-Tel calls, the serving IP Group is the 'Source IP Group
ID' configured in the Inbound IP Routing ta
ble (see Configuring the
Inbound IP Routing on page 414).
User Name
CLI: user-name
[Account_Username]
Defines the digest MD5 Authentication username.
The valid value is a string of up to 50 characters.
Password
CLI: password
[Account_Password]
Defines the digest MD5 Authentication password.
The valid value is a string of up to 50 characters.
Host Name
CLI: host-name
[Account_HostName]
Defines the Address of Record (AOR) host name. The host name
appears in SIP REGISTER From/To headers as
ContactUser@HostName. For a successful registration, the host
name is also included in the URI of the INVITE From header.
The valid value is a string of up to 49 characters.
Note:
If this parameter is not configured or if registration fails, the 'SIP
Group Name' parameter value configured in the IP Group table is
used instead.
Register
CLI: register
[Account_Register]
Enables registration.
 [0] No (Default)
 [1] Regular = Regular registration process. For more information,
see ''Regular Registration Mode'' on page 308.
 [2] GIN = Registration for legacy PBXs, using Global Identification
Number (GIN). For more information, see ''Single Registration for
Multiple Phone Numbers using GIN'' on page 308.
Notes:
 Gateway application: To enable registration, you also need to set
the 'Registration Mode' parameter to Per Account in the Trunk
Group Settings table (see Configuring Trunk Group Settings on
page 375).
 The account registration is not affected by the IsRegisterNeeded
parameter.
Contact User
CLI: contact-user
[Account_ContactUser]
Defines the AOR username. This appears in REGISTER From/To
headers as ContactUser@HostName, and in INVITE/200 OK Contact
headers as ContactUser@<device's IP address>.
Notes:
 If this parameter is not configured, the 'Contact User' parameter in
the IP Group table is used instead.
 If registration fails, the user part in the INVITE Contact header
contains the source party number.
Application Type
CLI: application-type
[Account_ApplicationType]
Defines the application type:
 [0] GW/IP2IP = (Default) Gateway application.
 [2] SBC = SBC application.