AudioCodes Mediant 500L MSBR

User's Manual 25. Trunk Group
Version 6.8 379 Mediant 500L MSBR
Parameter Description
Trunk Group Name
CLI: trunk-group-name
[TrunkGroupSettings_Trun
kGroupName]
Defines a name for the Trunk Group. This name represents the Trunk
Group in the SIP 'tgrp' parameter of the outgoing INVITE messages
(according to RFC 4904). For example:
sip:+16305550100;tgrp=TG-1;trunk-context=+1-
630@isp.example.net;user=phone
The valid value can be a string of up to 20 characters. By default, no
name is configured.
Notes:
 If this parameter is not configured, the Trunk Group decimal
number is used in the SIP 'tgrp' parameter.
 This feature is enabled by any of the following parameters:

UseSIPtgrp

UseBroadsoftDTG
 Currently, this parameter can only be configured using the ini file.
MWI Interrogation Type
CLI: mwi-interrogation-type
[TrunkGroupSettings_MWIIn
terrogationType]
Defines MWI QSIG-to-IP interworking for interrogating MWI
supplementary services:
 [255] Not Configured
 [0] None = Disables the feature.
 [1] Use Activate Only = MWI Interrogation messages are not sent
and only "passively" responds to MWI Activate requests from the
PBX.
 [2] Result Not Used = MWI Interrogation messages are sent, but
the result is not used. Instead, the device waits for MWI Activate
requests from the PBX.
 [3] Use Result = MWI Interrogation messages are sent, its results
are used, and the MWI Activate requests are used. MWI Activate
requests are interworked to SIP NOTIFY MWI messages. The SIP
NOTIFY messages are sent to the IP Group defined by the
NotificationIPGroupID parameter.
Note: This parameter appears in the table only if the
VoiceMailInterface parameter is set to 3 (QSIG). Configuring Voice
Mail on page 482.
Admin State (Read-only) Displays the administrators state:
 "Locked": The Lock command has been chosen from the Action
drop-down button.
 "Unlocked": The Unlock command has been chosen from the
Action drop-down button.