AudioCodes Mediant 500L MSBR

User's Manual 386 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
CLI: suffix-to-add
[Suffix2Add]
is 1234, the new number is 123400.
Web/EMS: Number of
Digits to Leave
CLI: num-of-digits-to-leave
[LeaveFromRight]
Defines the number of digits that you want to keep from the right of the
phone number. For example, if you enter 4 and the phone number is
00165751234, then the new number is 1234.
Web: NPI
EMS: Number Plan
CLI: npi
[NumberPlan]
Defines the Numbering Plan Indicator (NPI).
 [0] Unknown (default)
 [9] Private
 [1] E.164 Public
 [-1] Not Configured = value received from PSTN/IP is used
Notes:
 This parameter is applicable only to number manipulation tables for
IP-to-Tel calls.
 NPI can be used in the SIP Remote-Party-ID header by using the
EnableRPIHeader and AddTON2RPI parameters.
 For more information on available NPI/TON values, see Numbering
Plans and Type of Number on page 403.
Web: TON
EMS: Number Type
CLI: ton
[NumberType]
Defines the Type of Number (TON).
 If you selected 'Unknown' for the NPI, you can select Unknown [0].
 If you selected 'Private' for the NPI, you can select Unknown [0],
Level 2 Regional [1], Level 1 Regional [2], PISN Specific [3] or Level
0 Regional (Local) [4].
 If you selected 'E.164 Public' for the NPI, you can select Unknown
[0], International [1], National [
2], Network Specific [3], Subscriber [4]
or Abbreviated [6].
The default is 'Unknown'.
Notes:
 This parameter is applicable only to number manipulation tables for
IP-to-Tel calls.
 TON can be used in the SIP Remote-Party-ID header by using the
EnableRPIHeader and AddTON2RPI parameters.
 For more information on available NPI/TON values, see Numbering
Plans and Type of Number on page 403.
Web: Presentation
EMS: Is Presentation
Restricted
CLI: is-presentation-
restricted
[IsPresentationRestricted]
Enables caller ID.
 Not Configured = Privacy is determined according to the Caller ID
table (see Configuring Caller Display Information on page 492).
 [0] Allowed = Sends Caller ID information when a call is made using
these destination/source prefixes.
 [1] Restricted = Restricts Caller ID information for these prefixes.
Notes:
 This field is applicabl
e only to number manipulation tables for source
phone number manipulation.
 If this field is set to Restricted and the 'Asserted Identity Mode'
(AssertedIdMode) parameter is set to Add P-Asserted-Identity, the
From header in the INVITE message includes the following: From:
'anonymous' <sip: anonymous@anonymous.invalid> and 'privacy:
id' header.