User's Manual 5. Configuring Data-Router's LAN and WAN
Version 6.8 39 Mediant 500L MSBR
6. Enable Network Address Port Translation (NAPT) on the WAN interface:
(config-if-GE 0/0)# napt
7. Enable the WAN interface:
(config-if-GE 0/0)# no shutdown
8. Exit the interface:
(config-if-GE 0/0)# exit
9. Configure the default route:
(config-data)# ip route 0.0.0.0 0.0.0.0 100.33.2.106
GigabitEthernet 0/0
10. Exit the data-router configuration mode:
(config-data)# exit
11. Save the configuration to flash:
# write
To Next Page
Loading...
