AudioCodes Mediant 500L MSBR

User's Manual 27. Routing
Version 6.8 409 Mediant 500L MSBR

Rule 9 (IP-to-IP rule): If an incoming IP call from Source IP Group 2 with domain.com
as source host prefix in its SIP Request-URI, the IP call is sent to IP address
10.33.45.65.
Table 27-1: Example of Tel-to-IP Source Phone Number Manipulation Rules
Paramete
r
Rule 1 Rule 2 Rul
e 3
Rule 4 Rule 5 Rule 6 Rule 7 Rule 8
Src.
Trunk
Group ID
* 0 1 - - - - -
Src.
Trunk
Group ID
- - * 1 - * * *
Dest.
Phone
Prefix
10 10 20 [5,7-9] 00 100 100 100
Source
Phone
Prefix
100 100 * * * * * *
Dest. IP
Address
10.33.45.6
3
10.33.45.5
0
- domain.co
m
0.0.0.
0
10.33.45.6
8
10.33.45.6
7
domain.co
m
Dest IP
Group ID
- - 1 - - - - -
IP
Profile
ID
1 1 - - - - - -
Cost
Group ID
Weekend Weekend_
B
- - - - - -
Forking
Group
- - - 1 2 1
Table 27-2: Outbound IP Routing Table Parameter Descriptions
Parameter Description
Index
[PREFIX_Index]
Defines an index number for the new table record.
Web/EMS: Tel to IP Routing
Mode
CLI: configure voip > gw routing
general-setting > tel2ip-rte-mode
[RouteModeTel2IP]
Determines whether to route received calls to an IP destination
before or after manipulation of the destination number.
 [0] Route calls before manipulation = Calls are routed before
the number manipulation rules are applied (default).
 [1] Route calls after manipulation = Calls are routed after the
number manipulation rules are applied.
Notes:
 This parameter is not applicable if outbound proxy routing is
used.
 For number manipulation, see ''Configuring Source/Destination
Number Manipulation'' on page 381.
Route Name
CLI: route-name
[PREFIX_RouteName]
Defines an arbitrary name to easily identify the routing rule.
The valid value is a string of up to 20 characters. By default, no
value is defined.