User's Manual 30. Analog Gateway
Version 6.8 491 Mediant 500L MSBR
Parameter Description
Index
[TargetOfChannel_Index]
(Read-only) Displays the index number on the table
netry.
Module
[TargetOfChannel_Module]
(Read-only) Displays the module number on which the
port is located.
Port
CLI: port
[TargetOfChannel_Port]
(Read-only) Displays the port number.
Port Type
[TargetOfChannel_PortType]
(Read-only) Displays the port type (FXS or FXO).
Destination Phone Number
CLI: /dst-number
[TargetOfChannel_Destination]
Defines the destination telephone number to
automatically dial.
Auto Dial Status
CLI: auto-dial-status
[TargetOfChannel_Type]
Enables automatic dialing.
[0] Disable = Automatic dialing for the specific port
is disabled.
[1] Enable = (Default) Automatic dialing is enabled
and the phone number configured in the
'Destination Phone Number' field is automatically
dialed if the following occurs:
FXS interfaces: The phone is off-hooked
FXO interfaces: A ring signal (from a
PBX/PSTN switch) is detected on the FXO line.
The device initiates a call to the destination
without seizing the FXO line. The line is seized
only after the SIP call is answered.
[2] Hotline = Automatic dialing is done after an
interval configured by the 'Hotline Dial Tone
Duration' parameter:
FXS interfaces: When the phone is off-hooked
and no digit is dialed within a user-defined time,
the configured destination number is
automatically dialed.
FXO interfaces: If a ring signal is detected, the
device seizes the FXO line, plays a dial tone,
and then waits for DTMF digits. If no digits are
detected within a user-defined time, the
configured destination number is automatically
dialed by sending a SIP INVITE message with
Hotline Dial Tone Duration
CLI: hotline-dia-ltone-duration
[TargetOfChannel_HotLineToneDuration]
Defines the duration (in seconds) after which the
destination phone number is automatically dialed. This
is applicable only if the port has been configured for
Hotline (i.e., 'Auto Dial Status' is set to Hotline).
The valid value is 0 to 60. The default is 16.
Note: You can configure this Hotline interval for all
ports, using the global parameter,
HotLineToneDuration.
To Next Page
Loading...
