AudioCodes Mediant 500L MSBR

User's Manual 36. Routing SBC
Version 6.8 571 Mediant 500L MSBR
Parameter Description
request is routed according to the IP Group specific
database (i.e., only to registered users of the selected
database).
 If the destination IP Group ID is ANY USER ([-2]), the
request is routed according to the general database (i.e.,
any matching registered user).
Destination SRD ID
[IP2IPRouting_DestSRDID]
CLI: dst-srd-id
Defines the SRD ID. The default is None.
Note: The destination IP Group must belong to the
destination SRD if both are configured in this table.
Destination Address
[IP2IPRouting_DestAddress]
CLI: dst-address
Defines the destination to where the call is sent. This can be
an IP address or a domain name (e.g., domain.com).
If ENUM-based routing is used (i.e., the 'Destination Type'
parameter is set to ENUM) this parameter defines the IP
address or domain name (FQDN) of the ENUM service, for
example, e164.arpa, e164.customer.net or NRENum.net.
The device sends the ENUM query containing the
destination phone number to an external DNS server,
configured in the Interface table. The ENUM reply includes a
SIP URI (user@host) which is used as the destination
Request-URI in this routing table. The valid value is a string
of up to 50 characters.
Notes:
 This parameter is applicable only if the 'Destination Type'
parameter is set to Dest Address [1] or ENUM [3].
 When using domain names, enter a DNS server IP
address or alternatively, define these names in the
Internal DNS table (see ''Configuring the Internal SRV
Table'' on page 154).
 To terminate SIP OPTIONS messages at the device (i.e.,
to handle them locally), set this parameter to "internal".
Destination Port
[IP2IPRouting_DestPort]
CLI: dst-port
Defines the destination port to where the call is sent.
Destination Transport Type
[IP2IPRouting_DestTransportType]
CLI: dst-transport-type
Defines the transport layer type for sending the call:
 [-1] Not Configured (default)
 [0] UDP
 [1] TCP
 [2] TLS
Note: If this parameter is not configured, the transport type
is determined by the SIPTransportType parameter.