AudioCodes Mediant 500L MSBR

User's Manual 46. Software Upgrade
Version 6.8 635 Mediant 500L MSBR
46.1.5.3.1 Configuring SBC User Info Table in Web Interface
The following procedure describes how to configure the SBC User Info table in the Web
interface.
Note: If any User Info file is loaded to the device, all previously configured entries are
removed from the table in the Web interface and replaced with the entries from the
loaded User Info file.
 To configure the SBC User Info table in the Web interface:
1. Open the SBC User Info Table page (Configuration tab > VoIP menu > SIP
Definitions > User Information > SBC User Info Table).
2. Click Add; the following dialog box appears:
Figure 46-3: SBC User Info Table Page
3. Configure the SBC User Info table parameters according to the table below.
4. Click Submit.
5. To save the changes to flash memory, see ''Saving Configuration'' on page 606.
To register a user, select the user's table entry, and then from the Action button's drop-
down list, choose Register. To un-register a user, select the user, and then from the
Action button's drop-down list, choose Un-Register.
Table 46-3: SBC User Info Table Parameter Descriptions
Parameter Description
Index
[SBCUserInfoTable_Index]
Defines an index for the new table record.
Local User
[SBCUserInfoTable_LocalUser]
Defines the user and is used as the Request-URI user part for the
AOR in the database.
The valid value is a string of up to 10 characters.
Username
[SBCUserInfoTable_Username]
Defines the username for registering the user when
authentication is necessary.
The valid value is a string of up to 40 characters.
Password
[SBCUserInfoTable_Password]
Defines the password for registering the user when authentication
is necessary.
The valid value is a string of up to 20 characters.
IP Group ID
[SBCUserInfoTable_IPGroupID]
Defines the IP Group ID to which the user belongs and is used as
the Request-URI source host part for the AOR in the database.