AudioCodes Mediant 500L MSBR

User's Manual 696 Document #: LTRT-10466
Mediant 500L MSBR
Figure 54-7: CDR History Table
Table 54-3: CDR History Table
Field Description
Call End Time
Displays the time at which the call ended. The time is displayed in the
format, hh:mm:ss, where hh is the hour, mm the minutes and ss the
seconds (e.g., 15:06:36).
End Point
Displays the device's endpoint involved in the call, displayed in the
format:
 Analog: <interface>-<module>/<port>. For example, "FXS-3/1"
denotes FXS module 3, port 1.
 Digital: <interface>-<module>/<Trunk ID>/<B-channel>. For
example, "ISDN-1/2/3" denotes ISDN module 1, Trunk ID 2, B-
channel 3.
Caller
Displays the phone number (source number) of the party who made
the call.
Callee
Displays the phone number (destination number) of the party to whom
the call was made.
Direction
Displays the direction of the call with regards to IP and Tel sides:
 "Incoming": IP-to-Tel call
 "Outgoing": Tel-to-IP call
Remote IP
Displays the IP address of the call party. For an "Incoming" call, this is
the source IP address; for an "Outgoing" call, this is the destination IP
address.
Duration
Displays the duration of the call, displayed in the format hh:mm:ss,
where hh is hours, mm minutes and ss seconds. For example,
00:01:20 denotes 1 minute and 20 seconds.
Termination Reason
Displays the reason for the call being released (ended). For example,
"NORMAL_CALL_CLEAR" indicates a normal off-hoo
k (hang up) of the
call party.
Session ID
Displays the SIP session ID of the call.