AudioCodes Mediant 500L MSBR

User's Manual 67. Configuration Parameters Reference
Version 6.8 829 Mediant 500L MSBR
Parameter Description
For a description o this table, see Configuring Authentication
on page 489.
Note: This parameter is applicable only to FXS and FXO
interfaces.
Account Table
Web: Account Table
EMS: SIP Endpoints > Account
CLI: configure voip > sip-definition
account
[Account]
This table parameter configures the Account table for
registering and/or authenticating (digest) Trunk Groups or IP
Groups (e.g., an IP-PBX) to another Serving IP Group (e.g., an
Internet Telephony Service Provider - ITSP).
The format of the ini file table parameter is as follows:
[Account]
FORMAT Account_Index = Account_ServedTrunkGroup,
Account_ServedIPGroup, Account_ServingIPGroup,
Account_Username, Account_Password, Account_HostName,
Account_Register, Account_ContactUser,
Account_ApplicationType;
[\Account]
For a detailed description of this table, see ''Configuring
Registration Accounts'' on page 305.
Proxy Registration Parameters
Web: Use Default Proxy
EMS: Proxy Used
CLI: enable-proxy
[IsProxyUsed]
Enables the use of Proxy Set ID 0 (for backward compatibility).
 [0] No = (Default) Proxy Set 0 is not used.
 [1] Yes = Proxy Set ID 0 is used.
Notes:
 This parameter must be used only for backward
compatibility. If not required for backward compatibility,
make sure that this parameter is disabled, and use the
Proxy Set table for configuring all your Proxy Sets (except
for Proxy Set ID 0).
 If you are not using a proxy server, you must configure
routing rules to route the call.
 This parameter is applicable only to the Gateway
application.
Web/EMS: Proxy Name
CLI: proxy-name
[ProxyName]
Defines the Home Proxy domain name. If specified, this name
is used as the Request-URI in REGISTER, INVITE and other
SIP messages, and as the host part of the To header in INVITE
messages. If not specified, the Proxy IP address is used
instead.
The valid value is a string of up to 49 characters.
Note: This parameter functions together with the
UseProxyIPasHost parameter.
Web: Use Proxy IP as Host
CLI: use-proxy-ip-as-host
[UseProxyIPasHost]
Enables the use of the proxy server's IP address (in dotted-
decimal notation) as the host name in SIP From and To
headers in REGISTER requests.
 [0] Disable (default)
 [1] Enable
If this parameter is disabled and the device registers to an IP
Group (i.e., proxy server), it uses the string configured by the
ProxyName parameter as the host name in the REGISTER's
Request-URI and uses the string configured by the IP Group