AudioCodes Mediant 500L MSBR

User's Manual 834 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
Proxy IP Table
Web: Proxy IP Table
EMS: Proxy IP
CLI: configure voip > voip-network
proxy-ip
[ProxyIP]
This table parameter defines the Proxy Set table with Proxy
Set IDs, each with up to 10 Proxy server IP addresses (or
FQDN).
The format of the ini file table parameter is as follows:
[ProxyIP]
FORMAT ProxyIp_Index = ProxyIp_IpAddress,
ProxyIp_TransportType, ProxyIp_ProxySetId;
[\ProxyIP]
For a description of this table, see ''Configuring Proxy Sets'' on
page 297.
To configure the Proxy Set attributes (such as Proxy Load
Balancing) in the ini file, use the ProxySet parameter.
Proxy Set Table
Web: Proxy Set Table
EMS: Proxy Set
CLI: configure voip > voip-network
proxy-set
[ProxySet]
This table parameter defines the Proxy Set ID table. This
includes, for example, Proxy keep-
alive and load balancing and
redundancy mechanisms.
The format of the ini file table parameter is as follows:
[ ProxySet ]
FORMAT ProxySet_Index = ProxySet_ProxyName,
ProxySet_EnableProxyKeepAlive,
ProxySet_ProxyKeepAliveTime,
ProxySet_ProxyLoadBalancingMethod,
ProxySet_IsProxyHotSwap, ProxySet_SRD,
ProxySet_ClassificationInput,
ProxySet_ProxyRedundancyMode,
ProxySet_DNSResolveMethod,
ProxySet_KeepAliveFailureResp;
[ \ProxySet ]
For a description of this table, see ''Configuring Proxy Sets'' on
page 297.
For configuring the IP addresses per Proxy Set in the ini file,
use the ProxyIP parameter.
Registrar Parameters
Web: Enable Registration
EMS: Is Register Needed
CLI: enable-registration
[IsRegisterNeeded]
Enables the device to register to a Proxy/Registrar server.
 [0] Disable = (Default) The device doesn't register to
Proxy/Registrar server.
 [1] Enable = The device registers to Proxy/Registrar server
when the device is powered up and at every user-defined
interval (configured by the parameter RegistrationTime).
Notes:
 This parameter is applicable only to the Gateway
application.
 The device sends a REGISTER request for each channel or
for the entire device (according to the AuthenticationMode
parameter).