User's Manual 67. Configuration Parameters Reference
Version 6.8 847 Mediant 500L MSBR
Parameter Description
The device can receive session-timer refreshes using both
methods.
The UPDATE message used for session-timer is excluded from
the SDP body.
[RemoveToTagInFailureRes
ponse]
Determines whether the device removes the ‘to’ header tag from final
SIP failure responses to INVITE transactions.
[0] = (Default) Do not remove tag.
[1] = Remove tag.
[EnableRTCPAttribute]
Enables the use of the 'rtcp' attribute in the outgoing SDP.
[0] = Disable (default)
[1] = Enable
Note: This parameter is applicable only to the Gateway application.
EMS: Options User Part
[OPTIONSUserPart]
Defines the user part value of the Request-URI for outgoing SIP
OPTIONS requests. If no value is configured, the endpoint number
(analog) or configuration parameter ‘Username’ value (digital) is
used.
A special value is ‘empty’, indicating that no user part in the Request-
URI (host part only) is used.
The valid range is a 30-character string. By default, this value is not
defined.
CLI: configure voip/gw
digitalgw digital-gw-
parameters/trunk-status-
reporting
[TrunkStatusReportingMode]
Enables the device to not respond to received SIP OPTIONS
messages from, and/or send keep-alive messages to, a proxy server
associated with Trunk Group ID 1 if all its member trunks are down.
[0] Disable (default)
[1] Don’t reply OPTIONS = The device does not respond to SIP
OPTIONS received from the proxy associated with Trunk Group 1
when all its trunks are down.
[2] Don’t send Keep-Alive = The device does not send keep-alive
messages to the proxy associated with Trunk Group 1 when all its
trunks are down.
[3] Don’t Reply and Send = Both options [1] and [2] are applied.
Notes:
When this parameter is set to not respond to SIP OPTIONS
received from the proxy, it is applicable only if the OPTIONS
message does not include a user part in the Request-URI.
The proxy server is determined by the Proxy Set that is
associated with the Serving IP Group defined for the Trunk Group
in the Trunk Group Settings table.
Web: Fax Signaling Method
EMS: Fax Used
CLI: fax-sig-method
[IsFaxUsed]
Global parameter that defines the SIP signaling method for
establishing and transmitting a fax session when the device detects
a fax. You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_IsFaxUsed). For a detailed description of
this parameter and for configuring this functionality in the IP Profile
table, see ''Configuring IP Profiles'' on page 332.
Note: If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated with
the IP Profile.
To Next Page
Loading...
