AudioCodes Mediant 500L MSBR - Page 851

User's Manual 67. Configuration Parameters Reference
Version 6.8 851 Mediant 500L MSBR
Parameter Description
Web: Use user=phone in
From Header
EMS: Is User Phone In From
CLI: phone-in-from-hdr
[IsUserPhoneInFrom]
Determines whether the 'user=phone' string is added to the From
and Contact SIP headers.
 [0] No = (Default) Doesn't add 'user=phone' string.
 [1] Yes = 'user=phone' string is part of the From and Contact
headers.
Web: Use Tel URI for
Asserted Identity
CLI: uri-for-assert-id
[UseTelURIForAssertedID]
Determines the format of the URI in the P-Asserted-Identity and P-
Preferred-Identity headers.
 [0] Disable = (Default) 'sip:'
 [1] Enable = 'tel:'
Web: Tel to IP No Answer
Timeout
EMS: IP Alert Timeout
CLI: tel2ip-no-ans-timeout
[IPAlertTimeout]
Defines the time (in seconds) that the device waits for a 200 OK
response from the called party (IP side) after sending an INVITE
message, for Tel-to-IP calls. If the timer expires, the call is released.
The valid range is 0 to 3600. The default is 180.
Web: Enable Remote Party ID
EMS: Enable RPI Header
CLI: remote-party-id
[EnableRPIheader]
Enables Remote-Party-Identity headers for calling and called
numbers for Tel-to-IP calls.
 [0] Disable (default).
 [1] Enable = Remote-Party-Identity headers are generated in SIP
INVITE messages for both called and calling numbers.