AudioCodes Mediant 500L MSBR

User's Manual 67. Configuration Parameters Reference
Version 6.8 867 Mediant 500L MSBR
Parameter Description
Web/EMS: SIT Q850 Cause
[SITQ850Cause]
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when a Special Information Tone
(SIT) is detected on an IP-to-Tel call.
The valid range is 0 to 127. The default is 34.
Note: For mapping specific SIT tones, you can use the
SITQ850CauseForNC, SITQ850CauseForIC, SITQ850CauseForVC,
and SITQ850CauseForRO parameters.
Web/EMS: SIT Q850 Cause
For NC
[SITQ850CauseForNC]
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-NC (No Circuit Found
Special Information Tone) is detected from the Tel side for IP-to-Tel
calls.
The valid range is 0 to 127. The default is 34.
Notes:
 When not configured (i.e., default), the SITQ850Cause parameter
is used.
 This parameter is applicable only to FXO interfaces.
Web/EMS: SIT Q850 Cause
For IC
[SITQ850CauseForIC]
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-IC (Operator Intercept
Special Information Tone) is detected from the Tel for IP-to-Tel calls.
The valid range is 0 to 127. The default is -1 (not configured).
Note: When not configured (i.e., default), the SITQ850Cause
parameter is used.
Web/EMS: SIT Q850 Cause
For VC
[SITQ850CauseForVC]
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-VC (Vacant Circuit -
non-registered number Special Information Tone) is detected from
the Tel for IP-to-Tel calls.
The valid range is 0 to 127. The default is -1 (not configured).
Note: When not configured (i.e., default), the SITQ850Cause
parameter is used.
Web/EMS: SIT Q850 Cause
For RO
[SITQ850CauseForRO]
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-RO (Reorder - System
Busy Special Information Tone) is detected from the Tel for IP-to-Tel
calls.
The valid range is 0 to 127. The default is -1 (not configured).
Note: When not configured (i.e., default), the SITQ850Cause
parameter is used.
[GWInboundManipulationSet] Selects the Manipulation Set ID for manipulating all inbound INVITE
messages. The Manipulation Set is defined using the
MessageManipulations parameter. By default, no manipulation is
done (i.e. Manipulation Set ID is set to -1).
Note: This parameter is applicable only to the Gateway application.
[GWOutboundManipulationSet
]
Selects the Manipulation Set ID for manipulating all outbound INVITE
messages. The Manipulation Set is defined using the
MessageManipulations parameter. By default, no manipulation is
done (i.e. Manipulation Set ID is set to -1).
Notes:
 This parameter is used only if the Outbound Message
Manipulation Set parameter of the destination IP Group is not set.
 This parameter is applicable only to the Gateway application.