AudioCodes Mediant 500L MSBR

User's Manual 906 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
CallerDisplayInfo 0 = Susan C.,0,1,1; ("Susan C." is sent as
the Caller ID for Port 1 of Module 1)
CallerDisplayInfo 1 = Mark M.,0,1,2; ("Mark M." is sent as
Caller ID for Port 2 of Module 1)
For a detailed description of this table, see Configuring Caller
Display Information on page 492.
Notes:
 The indexing of this table ini file parameter starts at 0.
 This parameter is applicable only to FXS and FXO
interfaces.
Web/EMS: Enable Caller ID
CLI: enable-caller-id
[EnableCallerID]
Global parameter that enables Caller ID.
 [0] Disable (default)
 [1] Enable =

FXS: The calling number and display text (from IP) are
sent to the device's port.

FXO or CAS: The device detects the Caller ID signal
received from the Tel and sends it to the IP in the SIP
INVITE message (as the 'Display' element).
To configure the Caller ID string per port, see Configuring Caller
Display Information on page 492. To enable or disable caller ID
generation / detection per port, see Configuring Caller ID
Permissions on page 495.
Web: Caller ID Type
EMS: Caller id Types
CLI: caller-ID-type
[CallerIDType]
Determines the standard used for detection (FXO) and
generation (FXS) of Caller ID, and detection (FXO) / generation
(FXS) of MWI (when specified) signals:
 [0] Standard Bellcore = (Default) Caller ID and MWI
 [1] Standard ETSI = Caller ID and MWI
 [2] Standard NTT
 [4] Standard BT = Britain
 [16] Standard DTMF Based ETSI
 [17] Standard Denmark = Caller ID and MWI
 [18] Standard India
 [19] Standard Brazil
Notes:
 This parameter is applicable only to FXS and FXO
interfaces.
 Typically, the Caller ID signals are generated / detected
between the first and second rings. However, sometimes the
Caller ID is detected before the first ring signal. In such a
scenario, set the RingsBeforeCallerID parameter to 0.
 Caller ID detection for Britain [4] is not supported on the
device’s FXO ports. Only FXS ports can generate the Britain
[4] Caller ID.
 To select the Bellcore Caller ID sub standard, use the
BellcoreCallerIDTypeOneSubStandard parameter. To select
the ETSI Caller ID substandard, use the
ETSICallerIDTypeOneSubStandard parameter.
 To select the Bellcore MWI sub standard, use the
BellcoreVMWITypeOneStandard parameter. To select the
ETSI MWI sub standard, use the
ETSIVMWITypeOneStandard parameter.