AudioCodes Mediant 500L MSBR

User's Manual 926 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
The format of this table ini file parameter is as follows:
FORMAT ResourcePriorityNetworkDomains_Index =
ResourcePriorityNetworkDomains_Name,
ResourcePriorityNetworkDomains_EnableIp2TelInterworking;
ResourcePriorityNetworkDomains 1 = dsn, 0;
ResourcePriorityNetworkDomains 2 = dod, 0;
ResourcePriorityNetworkDomains 3 = drsn, 0;
ResourcePriorityNetworkDomains 5 = uc, 1;
ResourcePriorityNetworkDomains 7 = cuc, 0;
[ \ResourcePriorityNetworkDomains ]
Notes:
 Indices 1, 2, 3, 5, and 7 cannot be modified and are defined
for DSN, DOD, DRSN, UC, and CUC, respectively.
 If the MLPPDefaultNamespace parameter is set to -1,
interworking from PSTN NI digits is done automatically.
Web/EMS: Default Call Priority
CLI: dflt-call-prio
[SIPDefaultCallPriority]
Determines the default call priority for MLPP calls.
 [0] 0 = (Default) ROUTINE
 [2] 2 = PRIORITY
 [4] 4 = IMMEDIATE
 [6] 6 = FLASH
 [8] 8 = FLASH-OVERRIDE
 [9] 9 = FLASH-OVERRIDE-OVERRIDE
If the incoming SIP INVITE request doesn't contain a valid
priority value in the SIP Resource-Priority header, the default
value is used in the Precedence IE (after translation to the
relevant ISDN Precedence value) of the outgoing PRI Setup
message.
If the incoming PRI Setup message doesn't contain a valid
Precedence Level value, the default value is used in the
Resource-Priority header of the outgoing SIP INVITE request. In
this scenario, the character string is sent without translation to a
numerical value.
Web: MLPP DiffServ
EMS: Diff Serv
CLI: mlpp-diffserv
[MLPPDiffserv]
Defines the DiffServ value (differentiated services code
point/DSCP) used in IP packets containing SIP messages that
are related to MLPP calls. This parameter defines DiffServ for
incoming and outgoing MLPP calls with the Resource-Priority
header.
The valid range is 0 to 63. The default is 50.
Web/EMS: Preemption Tone
Duration
CLI: preemp-tone-dur
[PreemptionToneDuration]
Defines the duration (in seconds) in which the device plays a
preemption tone to the Tel and IP sides if a call is preempted.
The valid range is 0 to 60. The default is 3.
Note: If set to 0, no preemption tone is played.
Web: MLPP Normalized Service
Domain
EMS: Normalized Service Domain
CLI: mlpp-norm-ser-dmn
[MLPPNormalizedServiceDomain]
Defines the MLPP normalized service domain string. If the
device receives an MLPP ISDN incoming call, it uses the
parameter (if different from ‘FFFFFF’) as a Service domain in
the SIP Resource-Priority header in outgoing INVITE messages.
If the parameter is configured to ‘FFFFFF’, the Resource-Priority
header is set to the MLPP Service Domain obtained from the
Precedence IE.
The valid value is 6 hexadecimal digits. The default is ‘000000’.