User's Manual 928 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
[1] Enable = (Default) Adds the SIP resource-priority tag in
the SIP Require header.
Note: This parameter is applicable only to MLPP priority call
handling (i.e., only when the CallPriorityMode parameter is set
to 1).
Multiple Differentiated Services Code Points (DSCP) per MLPP Call Priority Level (Precedence)
Parameters
The MLPP service allows placement of priority calls, where properly validated users can preempt
(terminate) lower-priority phone calls with higher-priority calls. For each MLPP call priority level, the
DSCP can be set to a value from 0 to 63. The Resource Priority value in the Resource-Priority SIP
header can be one of the following:
MLPP Precedence Level Precedence Level in Resource-Priority SIP Header
0 (lowest) routine
2 priority
4 immediate
6 flash
8 flash-override
9 (highest) flash-override-override
Web/EMS: RTP DSCP for MLPP
Routine
CLI: dscp-4-mlpp-rtn
[MLPPRoutineRTPDSCP]
Defines the RTP DSCP for MLPP Routine precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
Web/EMS: RTP DSCP for MLPP
Priority
CLI: dscp-4-mlpp-prio
[MLPPPriorityRTPDSCP]
Defines the RTP DSCP for MLPP Priority precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
Web/EMS: RTP DSCP for MLPP
Immediate
CLI: dscp-4-mlpp-immed
[MLPPImmediateRTPDSCP]
Defines the RTP DSCP for MLPP Immediate precedence call
level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
Web/EMS: RTP DSCP for MLPP
Flash
CLI: dscp-4-mlpp-flsh
[MLPPFlashRTPDSCP]
Defines the RTP DSCP for MLPP Flash precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
Web/EMS: RTP DSCP for MLPP
Flash Override
CLI: dscp-4-mlpp-flsh-ov
[MLPPFlashOverRTPDSCP]
Defines the RTP DSCP for MLPP Flash-Override precedence
call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
Web/EMS: RTP DSCP for MLPP
Defines the RTP DSCP for MLPP Flash-Override-Override
To Next Page
Loading...
