AudioCodes Mediant 500L MSBR - Page 955

User's Manual 67. Configuration Parameters Reference
Version 6.8 955 Mediant 500L MSBR
Parameter Description
Web: Set PI in Rx Disconnect
Message
EMS: Set PI For Disconnect
Msg
CLI: pi-in-rx-disc-msg
[PIForDisconnectMsg_x]
Defines the device's behavior per trunk when a Disconnect
message is received from the ISDN before a Connect message is
received.
 [-1] Not Configured = (Default) Sends a 183 SIP response
according to the received progress indicator (PI) in the ISDN
Disconnect message. If PI = 1 or 8, the device sends a 183
response, enabling the PSTN to play a voice announcement to
the IP side. If there isn't a PI in the Disconnect message, the call
is released.
 [0] No PI = Doesn't send a 183 response to IP. The call is
released.
 [1] PI = 1; [8] PI = 8: Sends a 183 response to IP.
Note: The x in the ini file parameter name denotes the trunk
number, where 0 is Trunk 1.
EMS: Connect On Progress Ind
[ConnectOnProgressInd]
Enables the play of announcements from IP to Tel without the need
to answer the Tel-to-
IP call. It can be used with PSTN networks that
don't support the opening of a TDM channel before an ISDN
Connect message is received.
 [0] = (Default) Connect message isn't sent after SIP 183
Session Progress message is received.
 [1] = Connect message is sent after SIP 183 Session Progress
message is received.
Web: Local ISDN Ringback
Tone Source
EMS: Local ISDN RB Source
CLI: local-isdn-rbt-src
[LocalISDNRBSource_x]
Determines whether the ringback tone is played to the ISDN by the
PBX/PSTN or by the device, per trunk.
 [0] PBX = (Default) PBX/PSTN plays the ringback tone.
 [1] Gateway = The device plays the ringback tone.
Notes:
 This parameter is used together with the PlayRBTone2Trunk
parameter.
 The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Web/EMS: PSTN Alert Timeout
CLI: pstn-alrt-timeout
[TrunkPSTNAlertTimeout_x]
Defines the Alert Timeout (ISDN T301 timer) in seconds for
outgoing calls to PSTN, per trunk. This timer is used between the
time that an ISDN Setup message is sent to the Tel side (IP-to-Tel
call establishment) and a Connect message is received. If Alerting
is received, the timer is restarted.
The range is 1 to 600. The default is 180.
Note: The x in the ini file parameter name denotes the trunk
number, where 0 is Trunk 1.
Web: B-Channel Negotiation
EMS: B-Channel Negotiation
For Trunk Mode
[BChannelNegotiationForTru
nk_x]
Determines the ISDN B-channel negotiation mode, per trunk.
 [-1] Not Configured = (Default) Use per device configuration of
the BChannelNegotiation parameter.
 [0] Preferred.
 [1] Exclusive.
 [2] Any.
Notes:
 The option Any is only applicable if TerminationSide is set to 0
(i.e., User side).
 The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.