User's Manual 970 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
Tone
CLI: time-b4-reordr-tn
[TimeBeforeReorderTone]
starts playing a reorder tone to the FXS phone.
The valid range is 0 to 60. The default is 0.
Note: This parameter is applicable only to FXS interfaces.
Web: Cut Through Reorder
Tone Duration [sec]
CLI: cut-thru-reord-dur
[CutThroughTimeForReOr
derTone]
Defines the duration (in seconds) of the reorder tone played to the Tel
side after the IP call party releases the call, for the Cut-Through
feature. After the tone stops playing, an incoming call is immediately
answered if the FXS is off-hooked (for analog interfaces) or the PSTN
is connected (for digital interfaces).
The valid values are 0 to 30. The default is 0 (i.e., no reorder tone is
played).
Note: To enable the Cut-Through feature, use the DigitalCutThrough
(for CAS channels) or CutThrough (for FXS channels) parameters.
Web/EMS: Enable Comfort
Tone
CLI: comfort-tone
[EnableComfortTone]
Determines whether the device plays a comfort tone (Tone Type #18)
to the FXS/FXO endpoint after a SIP INVITE is sent and before a SIP
18x response is received.
[0] Disable (default)
[1] Enable
Note: This parameter is applicable to FXS and FXO interfaces.
[WarningToneDuration]
Defines the duration (in seconds) for which the offhook warning tone is
played to the user.
The valid range is -1 to 2,147,483,647. The default is 600.
Notes:
A negative value indicates that the tone is played infinitely.
This parameter is applicable only to analog interfaces.
Web: Play Busy Tone to Tel
CLI: play-bsy-tone-2tel
[PlayBusyTone2ISDN]
Enables the device to play a busy or reorder tone to the PSTN after a
Tel-to-IP call is released.
[0] Don't Play = (Default) Immediately sends an ISDN Disconnect
message.
[1] Play when Disconnecting = Sends an ISDN Disconnect
message with PI = 8 and plays a busy or reorder tone to the PSTN
(depending on the release cause).
[2] Play before Disconnect = Delays the sending of an ISDN
Disconnect message for a user-defined time (configured by the
TimeForReorderTone parameter) and plays a busy or reorder tone
to the PSTN. This is applicable only if the call is released from the
IP [Busy Here (486) or Not Found (404)] before it reaches the
Connect state; otherwise, the Disconnect message is sent
immediately and no tones are played.
Note: This parameter is applicable only to digital PSTN interfaces.
CLI: configure voip > gw
digitalgw digital-gw-
parameters > q850-reason-
code-2play-user-tone
[Q850ReasonCode2PlayUs
erTone]
Defines an ISDN Q.8931 release cause code(s), which if mapped to
the SIP release reason received from the IP side, causes the device
play a user-defined tone from the installed PRT file to the Tel side.
For example, if the the received SIP release cause is 480 Temporarily
Unavailable and you configure this parameter with Q.931 release code
18 (No User Responding), the device plays the user-defined tone to
the Tel side.
The user-defined tone is configured when creating the PRT file, using
AudioCodes DConvert utility. The tone must be assigned to the
"acSpecialConditionTone" (Tone Type 21) option in DConvert.
The parameter can be configured with up to 10 release codes. When
To Next Page
Loading...
