Field Description
restriction on the number of connected clients. If this number is
reached, new connection queries are initially rejected. If the cli-
ent cannot find another wireless network and, therefore, repeats
its query, the connection is accepted. Queries are only definit-
ively rejected when the Max. number of clients - hard limit is
reached.
The value of the Max. number of clients - soft limit must be
the same as or less than that of the Max. number of clients -
hard limit.
The default value is .
You can disable this function if you set Max. number of clients
- soft limit and Max. number of clients - hard limit to identical
values.
Client Band select
Not all devices support this function.
This function requires a dual radio setup where the same wire-
less networkis configured on both radio modules, but in different
frequency bands.
The Client Band select option enables clients to be moved
from the frequency band originally selected to a less busy one,
providing the client supports this. To achieve a changeover, the
connection attempt of a client is initially refused so that the cli-
ent repeats the attempt in a different frequency band.
Possible values:
• 5"1 +H $ $ #(default
value): The function is not used for this VSS. This is useful if
clients are to switch between different radio cells with as little
delay as possible, e. g. with Voice over WLAN.
• F @H " +$: Preference is given to accept-
ing clients in the 2.4 GHz band.
• @H " +$: Preference is given to accepting
clients in the 5 GHz band.
Fields in the menu MAC-Filter
8 Wireless LAN bintec elmeg GmbH
170 bintec RS Series
To Next Page
Loading...
